You saved me hours of frustration by showing me how to get that grommet into the tank. Thank you sir!
@hosseinfaraji5513 Жыл бұрын
Thank you for showing us the way it is done.
@smallengineguys Жыл бұрын
My pleasure 😊
@benkanobe75004 ай бұрын
Thank You! You provided everything that mattered with good video and clear audio and links that are current and correct. Thank you so very much!
@crisso1874 ай бұрын
Thanks for the video you made it really easy
@emmanueldavis2010 Жыл бұрын
Thanks
@smallengineguys Жыл бұрын
Welcome
@sensei1781 Жыл бұрын
The fuel priming bulb on my echo trimmer no longer seems to suck up fuel. I've replaced the 3 hoses, but still seems clogged up. Is there something that can be clogged within the carb that would prevent the bulb from priming? I guess I'll just buy the kit and replace everything, it's cheap enough.
@smallengineguys Жыл бұрын
bad primmer id replace everything including filter
@sensei1781 Жыл бұрын
@@smallengineguys Got around to replacing everything with the kit you linked. You were 100% right, my primer bulb had a tear in the bottom which wasnt allowing it to create suction. I went ahead and replaced everything in the kit anyway. Good as new :)
@Luv2flyMD3 жыл бұрын
Good video! Do you ever have to put a little oil on the grommet to get the fuel lines in hole?
@smallengineguys3 жыл бұрын
usually the kit comes all assembled. i used to though but i found it makes it a bit harder
@amd65ak47 Жыл бұрын
I have the same exact pair of hedge clippers I've changed the carburetor I've changed the fuel lines I've changed the grommet on the gas tank for the fuel lines I've changed the gasket on the fuel cap I've cleaned the muffler I put a new spark plug in it New ignition coil has good compression has new air filter all screws are tight It runs for I don't know but 5 to 10 minutes once it gets hot it stalls out and bogs Any solutions to my problem.
@smallengineguys Жыл бұрын
check and make sure the intake is tight but sounds like the crank seals and bearings are bad