Solving false pet-triggered alarms for the Takex (Optex) PIR alarm sensor

Solving false pet-triggered alarms for the Takex (Optex) PIR alarm sensor

[@lucianodisarno4328]

Thanks man!

[@moffatk7948]

Hi Great video. I have the same TAKEX beams around all four sides of my house, the problem is the one that is facing the sun, gives false alarm during the hot times of the day say 11am to 3pm. How can I resolve this problem.

[@mlinganimatiwane]

No man I know this accent isn't that the boere/afrikaaner accent from SA? If so hello mkhaya

[@Magezi]

Great video, it has helped me a couple of times. Could you please tell me what the "Delay Time" adjustment is for? I cannot find a definition in any literature or forum. Thanks

[@jasonsamuels5845]

How do you replace the batteries on the wireless ones on these sensors?

[@vaughanza]

Thanks for videos, Pls could you help and do a video or explain how do you re-connect or connect Optex wireless beam to an X64 alarm system. I changed the batteries and is not connected and would like to reconnect , thanks

[@fernandof6722]

Great video. Can u please give more potential false alarms. I have the 180 degree Takex installed but I keep getting false alarms. No pets. Installed in my front garden. In Summer i dont get false alarms only in Winter.

[@ecologicaltime]

i have been thinking about your comment. Is your winter quite cold? I had a wiring issue which only showed when it was cold. The wire was not making good contact and when the temp dropped it would loose connection. When the temp was higher it worked fine. please check this by measuring the resistance of the wire and resistor. Physically tug on the wires at the panel and sensor side to make sure they are connected correctly.

[@kaboboifang6066]

I'm also having the same problem by my garden. how did you resolved that?

[@mariuslaubscher9858]

I have rats in the roof, the sensor is outside but goes off during the very early morning hours