Рет қаралды 403
For further information, please visit:
adaptiverecogn...
adaptiverecogn...
The box contains the following items:
• Einar camera with bracket
• IP67 Weather Cap for RJ45 Plug
For the correct rain protection, you should hear a click sound when plugging in the cable.
• Ground Terminal
• 128 GB Micro SD Card
• Welcome Card with QR code
The 128 GB micro SD card is built into the camera.
You will find the storage setting in the third episode of the video series.
The Welcome Card’s QR code points to ARH document page.
Optional GPIO cable kit:
• GPIO cable,
• Sealing plate
• 2 piece screw
Tools to be provided by the Customer:
• 4 mm Allen key for adjusting the bracket
• Torx screwdriver for removeing the service port cover
Under the service port cover can be found:
• Micro SD card slot
• IO slot
• Factory reset button
The camera's power requirement is POE+. Cat5e or CAT 6 cable can you use. On the cable you first place the IP67 Weather Cap for RJ45 Plug, then crimp the RJ45 connector head on it.
For the correct rain protection, you should hear a click sound when plugging in the cable.
Close the IP67 weatherproof cap with your hand carefully, protecting the RJ45 connector.
KRIMPELÉS:
Stripping the outer sheathing from the network cable
Untwist and straighten out all 8 wires
Organising the colour-coded wires in the correct order
Sliding on the RJ45 Snap Plug, allowing wires to "pass through
Crimping the end and trimming the wires
Testing the ethernet cable with network cable tester
Steps to connect the GPIO cable:
1. unscrew the fixing screws of the cover plate using the Torx screwdriver
2. install the sealing plate in the package
3. plug the connector into the port
4. fix it with the longer screws provided in the package.
When the camera is powered, the status led under the optics first lights up red-yellow for two seconds, then turns green for two seconds, and finally goes out. The camera is now ready for use.
To learn more about EINAR, check out our entire video series:
• HOW-TO VIDEO SERIES - ...