REAR WINDOW REGULATOR REPLACEMENT REMOVAL FORD EDGE, LINCOLN MKX

[@ElectricalCarRepairLIVE]

⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: kzbin.info/door/k_lcDzEWLs5fVRYceK3-9Q ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys

[@JuniperoSerra-v1n]

This team should receive a recognition and support from the car made they are presenting. There mission was a success. kudos!

[@fico585]

Thank you for this video. I was able to fix my Edge by following this.

[@abdulhassan1107]

Same here.. Did the same, an hour ago! Great video!!

[@scooter8187]

Great video...very thorough. Saw another video where it was not necessary to remove the door latch assembly but it makes the removal/installation of the regulator a little more difficult due to tight access between the door and the black inner panel that the regulator attaches to.

[@virginiamatthews1908]

Thanks for the information on the puller. Did you have a recommendation for where to get the larger puller?

[@mikelittle1715]

Is it possible to remove the motor without taking the panel off? I see it and the three screws but the screw heads are very odd, are they a special type? 2011 MKx

[@nilesg75]

8:33 I dropped this bolt in the door. I really don't want to take the door apart again to fish it out. Is there a Ford diagram I can look at to find out what Torx screw it is? I doubt anyone is going to know the thread size and length.

[@Mineratron]

Very helpful, thanks for sharing.

[@henrysanchez4118]

What to do when the when the window is stuck down because there is two screws you can only unscrew when the window is up

[@aztecace]

Yeah the cable of my regulator broke and the window is down.

[@rm6913]

That’s what I want to know as well. I rolled down my window and it made a crunching noise and now my window is stuck all the way down and it won’t move.

[@Charlie-vw4dr]

Anyone get an answer to this (window stuck down)?

[@deleynav]

Take the door panel off and the liner around the window then pull the window up by putting something rubber on the window and pulling it with needle nose pliers

[@moparacer74]

If you remove the harness from the door pillar it unplugs there and you don't have to remove all of the wiring

[@RobertStarkey]

Forget this! I'm going to just take my car to a shop. This is WAYYYYYYY to complicated.

[@Kit-qc8lt]

Man how the Frick do i get a new window in

[@Kit-qc8lt]

In the back, same door, driver rear. Terrible.

[@hoagieman26]

Yeah, my neighbor has a broken one, I found an Edge in the pull-a-part junkyard, wasn't even able to remove the window before the yard closed...how does one remove the window glass??

[@Kit-qc8lt]

@@hoagieman26 it was very complicated but believe I got it in from the outside.. think I had to remove all the rubber window trim and most of the interior hardware but I don't remember.. I actually found another door and ended up changing the whole door out

[@btwichele]

thanks

[@NoushadKt-xp7nm]

Thank you dear

[@wilmadikphit]

I'm sure glad he doesn't have an accent that makes it hard to understand.

[@awbretire]

Hard to understand 😁