How to install the Elfa top rail. See Part 1, how to add wall anchors here: • Elfa Closet System DIY...
Пікірлер: 9
@karenruhlig28323 жыл бұрын
Thanks for posting 1 and 2!!!
@wonderbuss23272 жыл бұрын
Hope it was helpful!
@phenomjoy3 жыл бұрын
Thank you for posting this
@wonderbuss23272 жыл бұрын
No problem!
@lastboyscout1065 Жыл бұрын
Considering what this system costs, how important it is to fully tighten these anchors, and how many years it’s been out in the market, I’m amazed that Elfa has not Changed to a better screw head that does not strip as easily as the Philips screws!!!
@mmevenson4 жыл бұрын
Thanks for posting this. I would have like to have seen the hand tightening at the end. How tight will the screws get? Mine seem to not get all the way tight, they want to spring back.
@wonderbuss23274 жыл бұрын
After using a power drill with a phillips bit to get it tightened, finish with hand-tightening with a screwdriver and stop short when it doesn't seem it will turn any further without stripping the screw.
@ash556999 ай бұрын
I think you needed to further tightening the screws so that the spring behind the dry wall can coil and tightening the whole anchor
@ianscreamsvideo8 ай бұрын
You know you should set the clutch on your drill much lower like 3-5 so it clicks out when you get to a certain level of tension..less likely to strip the screw.