Elite Force 1911 leaking magazine fix.

[@bigd2829]

Awesome, only thing I would add is there is the same o ring on the inside of the mag where the co2 cartridge gets punctured. Just have to unscrew that and troubleshoot from there like you did. I would try your method first though, will give this a shot as I’ve found my mag is leaking. Awesome video!!!

[@AtHomeTacticalDefense]

Thanks! 🙏

[@Silencer1620]

Has it held up still after 9 months? I'm having leaking issues through the output valve, which is probably the same thing as your problem. I tried 2 solutions. 1st to lube the o-ring, and the 2nd is sealing the inside where the output seats in. They almost work, but I'm probably going to buy the o-rings as my last resort. If i do get the o-rings and it works, then I'll be thankful for you for helping me out

[@AtHomeTacticalDefense]

Yes! I’ve had one leak which was fixed with a 1/16th turn tighter on the valve and I tested a few mags by placing them to the side to sit for a few months with new cartridges, and they held their charge. I think I just didn’t torque that one quite hard enough initially. The o-rings work perfect.

[@Silencer1620]

​@AtHomeTacticalDefense so i just got the o-rings in today, and it works, but when I shoot it, it leaks out small amounts and stops. Idk if that's normal but I'm hoping it is. The longest it been leaking out is 6 seconds and that sounds bad. Its not leaking fast but slowly like a faint whistle. I'll probably have to change out the valve if that's the other problem.

[@yearRBLX]

I have this problem I don't know where to get the rings from can u tell me bc my gun is brand new and it worked for a while and then all the sudden I put a CO2 in there and it started leaking I took both of the valves out and make sure they are fine I think it might just be the o ring that need to be replaced

[@AtHomeTacticalDefense]

The instructions on where to get the o-rings and the size are in the video and description.

[@yearRBLX]

@@AtHomeTacticalDefense so basically the o ring outer diameter is 8mm and the inner diameter is 6mm and the cross-section diameter Is 1mm??

[@yearRBLX]

@@AtHomeTacticalDefense is that the right one bc im going to buy it

[@AtHomeTacticalDefense]

Correct.

[@yearRBLX]

@@AtHomeTacticalDefense ok thank you

[@not4yman]

I replaced the o-ring on my 3 mags, slathered it with lube and it still leaks from the top. Anything im doing wrong?

[@AtHomeTacticalDefense]

Take it apart and remove all of the lube. Install the o-rings dry. Never use lube when sealing high pressure gas.

[@jonnymak1079]

Whst if the air is flying through the top ?

[@AtHomeTacticalDefense]

Tighten the valve with a spanner wrench. If that doesn’t fix it, replace the o-ring. If it still leaks, replace the valve.

[@jonnymak1079]

@AtHomeTacticalDefense awsome Thsnk you :)

[@yearRBLX]

And is it 8mm x6mm x 1mm?

[@AtHomeTacticalDefense]

Yes. You can find them on Amazon.

[@loganresnick8187]

What is the link to this tool?

[@AtHomeTacticalDefense]

a.co/d/4Cf7bzN

[@loganresnick8187]

@@AtHomeTacticalDefense Thank you!!! Great video. Very informative!!