Em232 Analog Module Programming & Scaling | Part 13

[@angelxd5200]

I have the cpu 224xp add an EM232 module and I perform your steps of the ladder diagram, only I do not get the output of ma, you can support me

[@AutomationSpot]

for output ma you need to use another I pin not v ok dear?

[@ElectricalSolution]

When i used i EM223 in a machine, How can i change the value of inMOW?

[@AutomationSpot]

Use move functon already shown in my video. watch complete video.

[@shahaalom6891]

If I add an expansion modules , do I have to configure the hardware in software or direct give serial address.

[@AutomationSpot]

no need to configure the hardware direct use data register Thanks

[@MDNASEEM-wd6bi]

Salaam bhai, Mov _W ke enable command ko set and reset kaise karenge

[@AutomationSpot]

we will make videos new soon.

[@ismailsinapli]

good day ,good luck.

[@AutomationSpot]

Thanks, you too!