Engine failure to start due to a bad Relay

If your starter relay has gone bad, the electrical signal will never make it from the battery to the starter motor. As a result, your engine won't turn over - no matter how many times you press the run key. A faulty relay often produces an audible clicking sound when you press the run key or if you have a car with an ignition switch when you turn the key on to start the engine possible to hear it.
Generator Repair videos :
• Generator Repair Videos

[@antoniogonzalezmedel]

Congratulations 🎉

[@joelty250]

Very helpful Sir. Thank you

[@NashonJohn-eq7of]

Thanks sir .very informative

[@christopherfadera763]

Hello sir.new subcriber.

[@umehmmaduabuchi7879]

Thankyou for the video, please do the testing by Multi metre

[@northjayhoon9789]

Noted!

[@christopherfadera763]

Sir, can I ask for a wiring diagram of the same unit. Our unit at site is P200-2. We have a problem with our fuel solinoid voltage supplies.no voltage showing whilst starting and engine won't start. Thank you sir

[@northjayhoon9789]

Greetings Thank you for your request Please send me an email to [e-mail] I will send you the wiring diagram. All the best

[@DanielShiferaw-ob4xs]

Thank you for the video. Please kindly answer this question👉👉Why doe a Cummins generator controller(ps0600) reset the running hour and change the genset configuration by itself? Thanks!

[@northjayhoon9789]

Dear Sir Thank you for chosen DIY & Fix it Your controller may not programmed / calibrate well , By pressing ok and reset key you are gonna start calibration I wish to have PS0600 or PS0500 to make a You Tube video.

[@DanielShiferaw-ob4xs]

​@@northjayhoon9789 Grateful to your support🙏 I tried to enter into configuration mode and seen "J16-9 SENSOR SEL" changed into "Not connected" inside Genset configuration after the reset. When the reset occurs again the configuration is changed and due to this when a remote start signal is received the DG cranks but fails to start. Hopefully waiting you next video on 0ps600 controller.🙏

[@ibrahimkaplan6323]

👏👏

[@badoui]

How to problem alarem high volteg battrie ....?

[@northjayhoon9789]

Thank you for your enquiry! If your generator's controller indicates/ warning high battery alarm, definitely you need to check DC alternator . An alternator's output is controlled by an integrated voltage regulator, which is designed to prevent overcharge. You may have a faulty voltage regulator and it does over charge your battery.