Engraving Positioning Vise - no cost method

[@willplaut8900]

This even worked on my old school victor vice! Thanks Steve!!!

[@RT-gs7fj]

You put a y with a couple fingers and a U joint in the center upside down opposing the Y that would give you your drag after you take out the spindle shaft

[@thomasboswell3497]

hey steve what is the best material to make a piston ? Could you try heavier metals for a harder hit or is that overkill waste of time ? i was trying to find a metal that was hard but the heaviest. i seen Shaun use plastic ptfe or something. ii like the heavy solid hit in a hand piece.

[@millionmilesman]

Lindsay ya tiene los pistones de carburo de tungsteno, más pesados. Ya dolo te falta hacerlo de Osmio

[@millionmilesman]

Nice

[@bfflorida2311]

Cool trick thank you sir👍👍👍