Episode 6 - Introduction to using ACCORDO

[@speakerbox8230]

So simple, even us sales guys can do it! Thank you guys for always taking user-friendliness into account with your software, on top of building fantastic products across the lineup!

[@RobertCookcx]

I just installed the M8.14 and M1D in my Stinger with the Maestro AR interface only to learn that Accordo is not yet available for my situation. I had to laugh when I watched this whole video again - this time to the very end - to find that I am not losing it! Any timeline on when it will become available for the Maestro AR folks? Thanks

[@AudisonItofficial]

Dear Rober, Thank you for reaching out. Currently, there is no official release date for compatibility with Maestro AR, but please be assured that the Audison R&D team is actively working on this integration. We apologize for the inconvenience this may have caused and appreciate your patience. Best regards, Audison team

[@fabiancajas6178]

🎉🎉🎉🎉🎉🎉

[@8Meridian]

I have a next setup in my BMW G20 320i Basic Stereo with RAM: Audison AF C8.14bit, APBMW 8 4.2 (bridged channels) and APBMW K4E (using crossover, 2 channels on amp). OEM headunit iDrive 7 plus rear speakers. Without subwoofer. Are there any ready-made configuration files for the BMW systems?

[@AndruKalAndru]

has any one tried accordo yet and having issues? i get to the end of the wizard (where it counts down before it starts taking its measurements) and the whole program (bit drive) closes. I'm using a Dayton audio umm-6 mic

[@AudisonItofficial]

Dear Andru, Thank you for reaching out. We recommend downloading the latest software release for bit Drive 2.0.1.0 from our support page: audison.com/support/software-firmware/. This release addresses compatibility issues with the Dayton Audio UMM-6 microphone. We hope this resolves the problem you’ve encountered. If you have any further questions or issues, please let us know. Best regards, Audison team

[@AndruKalAndru]

@@AudisonItofficial i downloaded it a few weeks ago worked like a charm thank you 😁

[@robertwindeatt]

I have downloaded it but the accordo isnt on there when i click on the wizard?

[@PatrickKlinge-fu2tm]

The amp needs to be connected and fw up to date to 2.0 too.

[@RobertCookcx]

In addition to the comment from @PatrickKlinge-fu2tm, if you are using the Maestro AR interface in your application, Accordo is not yet available as of August 11, 2024.

[@dannymm]

I'm unable to get the accordo output level calibration signal into the green level even with the volume set to +6db and the minidsp calibrated mic setting at maximum in the windows settings. I'm stuck on signal low and unable to progress to the next step.

[@PatrickKlinge-fu2tm]

Umik-1 !? Open the case and set a proper gain for the mic with the dip switch

[@PatrickKlinge-fu2tm]

Umik-1 !? Open the case and set a proper gain for the mic with the dip switch

[@dannymm]

@@PatrickKlinge-fu2tm Yes the Umik-1, its currently set to 18db - which gain would you recommend? Thank you!

[@PatrickKlinge-fu2tm]

@@dannymm depends on windows.. try it out (Y)

[@dannymm]

@@PatrickKlinge-fu2tm I've changed it to 24db and now its outputting the correct level and the Accordo tune completed successfully. Many thanks!