Epson Head Cleaning, l110, l3110/L110, L210, L300, L350 & L355

[@monpiotr]

Dziękuje za ten poradnik dotyczący czyszczenia głowicy w drukarce epson. Wszystko dokładnie wyjaśnione. 😊

[@VNProductionofficial]

Thank you 👍

[@severinomacahiligjr.526]

Is it ok to use distilled water instead of cleaning solution?

[@msotil]

How do you clean up that ink (hands...)?

[@AvinashDhaker3232]

Kya Epson l355 ka head l210 ya l220 me use kar sakte he

[@hsynbrdk]

A nice demonstration of why we should wear disposable gloves before doing such cleaning. Nice tutorial though. I got what I need.

[@rithikashah1665]

Just use oil and soap and everything will come off in seconds

[@turongou]

Thank you for the video

[@Pixelsplasher]

7:40 _If by any chance the water goes, you need to keep it for 24 hours._ Not sure what he means by that. Maybe if the ribbon cable terminal of the print head gets into contact with the water, you need to wait 24 hours to make sure it is dry again?

[@Pixelsplasher]

UPDATE: Now I know why we must wait for 24 hours. I just learned that the print head fuse labeled F1 on the motherboard can be blown if the print head board comes into contact with water. The printer may operate normally but the dead print head will not print anything! The tutorial did not stress this important information.

[@shielamariemanzano6984]

hi po saan po nkakabili ng cycle tube?

[@rendHELL06]

lazada

[@rithikashah1665]

did not show after cleaning if it worked on not, dislike for that!

[@entertainmentknowledge5028]

My printer head totally blocked after this

[@Pixelsplasher]

Your print head fuse is probably blown due to short-circuit with water.

[@raulsipos315]

@@Pixelsplasher yes but can be fixed. Do you know where exactly is located because my axis moving but without colors and I cleaned with isopropanol.

[@Pixelsplasher]

The fuse is labeled F1 on the motherboard,@@raulsipos315 . It is located near the ribbon cable going to the printhead.

[@meandyoutarot]

Greetings, once tried to clean it on my own, but the info I referred didn't put stress on the head to get damage, and that happened. I had to take the printer to the service centre. It could cost around 3500 to 4000 depending on availability and sellers pricing.

[@meandyoutarot]

Hello, just completed cleaning, while doing so put on cello tape on the side where the cable is connected. After cleaning, I put the cartridge under the fan for some time and yup, it is ready to print.

[@Ватафакмазафака-ш1л]

Горе мастер, и то как не надо делать, давление в головке порвет мембрану, очень опасно, одним шприцом не стоит прокачивать все цвета, даже промывая в стакане.

[@yesno8204]

Dumb video.... What is the point if you not showing printing a test page.