DIY MOSFet Voltage Regulator without Potentiometer just using UP and Down Push Buttons and IRF3205

[@misha_mikheev]

it's a good idea, but if you turn off the power and turn it on, the transistor will not open completely?

[@FixitEasyDIY]

Перфектно. И музиката си подбрал отново добра!

[@ErCanEverything]

Благодаря Приятелю🙏🤝🤝🤝

[@GabiFodorrasRO]

Friend you are very talented ... Congratulations on what you do !!!

[@ErCanEverything]

Thank You very much my Friend🙏🤝🤝🤝

[@ZONAALATA]

Always full of ideas. Great job 👏

[@ErCanEverything]

Thank You my Friend🙏🤝

[@DjaniAgain]

Wow, very simple but does a great job! 😍

[@ErCanEverything]

Although the capacitor has a low capacity. When I turn it on after a while, the output voltage remains the same as before

[@samsungsexy7164]

@@ErCanEverything That's a nice feature 👌

[@djaniagaingaming9976]

Nice and easy! Great video as always 👌🏻

[@ErCanEverything]

Thank you Dostum🙂🤝🤝🤝

[@GabiFodorrasRO]

Hello! I subscribed

[@ahmedsoffy581]

good work

[@electronic7979]

👍

[@doctormicro]

👍👍👍😍😍😍

[@ahmedsoffy581]

my question : if you cut off power from the mosfet about 10 minutes . does it point again the same volt which you are switch off it ???/

[@jonatanrojas1138]

Hello, what is the maximum current that this circuit supports?

[@ErCanEverything]

105A According to the manufacturer

[@javiersoto570]

que capacidad tiene el condensador ceramico?

[@ErCanEverything]

564J = 560nF

[@MACYNET323]

Can I use instead Irfz44n or irf540?

[@ErCanEverything]

Of course

[@MACYNET323]

@@ErCanEverything Please made video for 10W 3V Led dim by knob from single lithium battery

[@minalobudeshte]

Хайде дай идея как да излъжа резачката на батерии от parkside лидл да мога да си я ползвам с външна батерия не оригинална. Като сложа 10ком резистор между минуса и температурния конектор тръгва резачката. Спра ли обаче остават някакви 2.5волта напрежение между минуса и температурният порт и след около 60секунди изчезват сами тези 2.5 волта и пак мога да я пусна. Как мога да ги елиминирам веднага тези 2.5 волта, така че да мога да я пускам и спирам не през 1 мин? Изключа ли плюса на батерията тези 2.5волта изчезват веднага. Но не е удобно така. Пробвах с диод но не става.

[@ahmedsoffy581]

ok but its current regulator not volt because the volt is stable

[@ErCanEverything]

The voltage remains stable because a maximum current of 8A has been reached and therefore cannot be increased more. At the end of the video it can be seen that the voltage is also regulated.