Thank for the stick time John! Had a good time out there!
@RCVideoReviews11 ай бұрын
Thank you for sharing your talent with us. Truly a pleasure to watch you do your thing.
@MrZeek10111 ай бұрын
Oh my gosh, what an amazing pilot that's going to be a tough act to follow. John, great job. Great build Dave. Great flight. Antonio and thanks for buying it. John 😂😅🤣
@RCVideoReviews11 ай бұрын
I've got my work cutout, that's for sure :) Gotta step it up I guess.
@davidpaker62611 ай бұрын
👍🙂
@ulfhedlund586111 ай бұрын
Very interesting to get the team pilots expert view and insights to trimming etc. Thanks for another great video!
@RCVideoReviews11 ай бұрын
You're very welcome. Thank you for the kind comment.
@davidpaker62611 ай бұрын
That was really Amazing flying , A great Show, The guys from extreme flight are very nice . and the airplane is gorgeous.
@RCVideoReviews11 ай бұрын
Amen 100% agree.
@reckemroysrc376411 ай бұрын
Love getting a pros advice on set up. Damm he's a good pilot 👏 👌 😊
@RCVideoReviews11 ай бұрын
No doubt!
@markhaman201811 ай бұрын
Great video. I liked the comments on high rates and tweak expo. Trying to work into that. I will watch again to figure out how he determined it was nose heavy for him.
@RCVideoReviews11 ай бұрын
During knife edge he had to hold more rudder than he liked for level ke flight. Moving the batteries back would allow less rudder for level ke flight and give more tail authority--which is important to 3D guys like this.
@michaelfargnoli350111 ай бұрын
Awesome .. Exciting having edgetx and elrs for fixed wing!. Thanks for the great content
@RCVideoReviews11 ай бұрын
You're welcome. Thanks for the kind comment.
@Tom-wl9sx11 ай бұрын
Nice flight and plane! That's really how all maidens should be done! 🙃
@robieosborne73693 ай бұрын
Hi, not sure if it was mentioned in the video but how much did this whole set up weigh?
@mhk10588 ай бұрын
Just great!
@RCVideoReviews8 ай бұрын
Right? Antonio is an amazing pilot.
@beonyou11 ай бұрын
Nice flight. Really appreciate the "light acrobatics" concept ! Tell Antonio to come back for a real strong acrobatics demo !!! :-D
@RCVideoReviews11 ай бұрын
Watch the last video I just posted. You'll get it.
@tap908310 ай бұрын
Wow very impressive. Thank you as always for a great informative video. Would you mind sharing your build, (Motor, esc, Servos) Thank you
@garycaruso48838 ай бұрын
At this size is a carbon prop really lighter? I would expect they are heavier? would like to know actual weights, which most places don't post in specs.
@The725Trap11 ай бұрын
Awesome maiden
@RCVideoReviews11 ай бұрын
Agreed
@FelipeCerdaBarra11 ай бұрын
Great video! BTW what's the airplane on the back at the end of the video? The one covered with a white cloth
@RCVideoReviews11 ай бұрын
That's an EF 67" Extra 260 RxR under the EF Solar Shield for 60-70" planes.
@jadamian7511 ай бұрын
I would like to see a video of the Blue and cub yellow Raven. It looks like the colors will pop in the air
@trevorfurlotte11 ай бұрын
Awesome. Is the parts list and setup in a video or posted on discord? If I wanted to assemble this exact plane has the complete list been posted? ESC, motor, servos, battery etc?
@RCVideoReviews11 ай бұрын
No. The motor is pre-production. The ESC is first time use (ZTW Mantis G2 130a), and since I didn't fly it, I didn't link it. Batteries are always Liperior. In this case 2x6s5000 75c. Servos are KST X20-4208. Xoar 22x10. Receiver is Radiomaster ER6 and I used a PDB from servo city.
@trevorfurlotte11 ай бұрын
@@RCVideoReviews thanks for the reply. I appreciate all your hard work and great content.
@waynemiller60706 ай бұрын
@@RCVideoReviews thanks, I heard 6S. But I didn't know if it was one or two. Sounds like Antonio would've gone for a lighter pair of batteries.
@waynemiller60706 ай бұрын
Would've liked to seen the canopy off, to see where the batteries were located.
@riskninja81947 ай бұрын
Antonio CRUSHED it! What motor were you using?
@RCVideoReviews7 ай бұрын
AM780 from tmotor.
@joeheffern511811 ай бұрын
What motor are you running in this plane? Power looked incredible..
@RCVideoReviews11 ай бұрын
It's a pre-production 40cc T-Motor. Not available retail just yet.
@cobaltjones10 ай бұрын
Amazing plane and flying. Let me ask you how much time can I expect with two 4S 3000mah each in series? The motor is a 35cc equivalent. 73" AJ Raven
@RCVideoReviews10 ай бұрын
Not much. This one flies for about 6m using 2x6s4k. You're going down in both voltage and capacity, so amperage goes up while your 'gas tank' goes down. My 70" slick flies with 6s6200 and it is on the low end of acceptable to me for flight time.
@cobaltjones10 ай бұрын
your 70" slick uses one or two six cells?@@RCVideoReviews
@cobaltjones10 ай бұрын
should I go with two 5k 6 cells?
@cobaltjones10 ай бұрын
My Avian 120 forbids the use of an auxiliary battery in the manual. It has two leads for the BEC. It claims the third battery is unnecessary. What do you think about this?
@RCVideoReviews10 ай бұрын
I think I'd find a different ESC.
@cobaltjones10 ай бұрын
It's designed specifically to not require additional components. They did spark a revolution with 2.4@@RCVideoReviews
@cobaltjones10 ай бұрын
you were right. the ESC started smoking and I quickly disconnected it and sent it back.@@RCVideoReviews
@heyjackfpv546925 күн бұрын
great video. I've been watching your videos since you're were out west flying eagle tree vector planes. I have a question , I want to buy a 3d plane either from extreme or PA, preferably a PNP or RXR, I have 20 plus years of experience flying warbirds and mainly Edfs, recently I'm practicing a lot of 3d flying on the simulator and I was wondering what plane do you recommend ? I would like one that is more floaty and forgiven , DO you mind pointing me to the right direction ?, I really appreciate . thank you
@RCVideoReviews24 күн бұрын
I think we discussed on the PJ tonight right? Twisted Hobby foamies are a good place to start with 3D, but if you want balsa, I'd check on a 60' Edge 540. Good starting point.
@heyjackfpv546924 күн бұрын
@@RCVideoReviewsyes sir , thank you
@cadbuildflyrc378411 ай бұрын
Nice airplane and flying.
@RCVideoReviews10 ай бұрын
Thanks. Great day all around.
@re306510 ай бұрын
May I ask what did he have set up for expo and rates?
@RCVideoReviews10 ай бұрын
No rates. 100% throw with 70% on elevator and aileron, 65% on rudder.
@re306510 ай бұрын
I am sorry, I asked the question before I watched the video all the way to the end in which it was discussed 😖😉 @@RCVideoReviews
@jaylargo531111 ай бұрын
SWEET AIRPLANE and yes max rates always🤨
@RCVideoReviews11 ай бұрын
Yeah, beautiful plane. Love it.
@danmartinrc11 ай бұрын
Did Antonio make you do a check ride before he handed it back to you? 😅