I'm working with the local civil protection director to make a prototype of a torpedo style rescue floatation device to be donated and mounted on natural wood posts at our most historically dangerous beaches. These torpedoes are abusively priced ($150 USD), not available locally here in México and not available in all-natural materials but I'm working to change that. We need a local bioplastics supplier with materials well suited for this purpose with sheet plastic that can be manually heat-formed over a mold. And for a much larger scale impact, we need an estimate of the cost of mold that could be used with recycled plastics, bioplastics and biodegradable plastics also to injection mold them for us. If we can raise the funds to pay for the mold ourselves, the devices can be relatively very inexpensive which will make them very accessible and help save lives everywhere they're used.
@nirmalgupta79182 жыл бұрын
R kn। C। c c wfc । Mk Fcl ।l Ll Mm k Fcl।f Z। । Wmk। M tkmmkmr kml। Fct mfnc। Kmrrf। ।। Fc। Lc snk।।SMC। । । K। ca। ।
@radhakantasahoo64482 жыл бұрын
It's very helpful to me 🙂 Thank you so much 🙏🙏🙏
@inayathussaingermanwala25483 жыл бұрын
It's very nice comments knowledge
@jalaaamasha3628 Жыл бұрын
Thankkkk you
@RaphaMasterOriginal2 жыл бұрын
hello, a doubt what would be the recommended blowing pressure for pieces from 5 to 10 liters (80 grams to 500 grams). And how do I know when I need more or less pressure.
@ronzx23ulpindo26 Жыл бұрын
What standard mold temperature for pp?
@nassaraloui43603 жыл бұрын
Good
@mostafanasehahadi23464 жыл бұрын
Thank you so much
@themistercookie85365 жыл бұрын
I need this dudes voice
@mohamedtayeb6523 Жыл бұрын
هل هناك نص مترجم الى العربيه
@saravananlatchu84768 жыл бұрын
My hot cutter blade is keep breaking off every eight hours, what could be the problem for this to occur.
@user-nt7yh9vt4r8 жыл бұрын
may be high voltage applied on the blade
@saravananlatchu84768 жыл бұрын
Owhh kk bro, thnks will check on it.
@pedroguzman3638 жыл бұрын
you need to check the amperage in the wires of the blade maybe you need to put lower voltage in the primary of the transformator I put 127 volts and the current go down to half
@MaheshPatil-dn4ku6 жыл бұрын
hi sir we are manufacturing of blow molds any requirement pls call me on this no 8000106807. from Ahmadabad Gujarat
@lxosito5 жыл бұрын
Or cheap blade, we bought this one that kept breakn on us and found out blade was cheap blade. Also the speed of the hot cutter blade.
@nidhal71846 жыл бұрын
Dear Sir, Good day to you. Please, is it possible to use PP blow material to use on injection machine? What is the effect on injection machines & molds? Thnx,,
@themistercookie85365 жыл бұрын
Bruh someone answer his question he been waiting a year.
@izzatroslan43684 жыл бұрын
yes, it is possible. Please be aware that PP have higher melting point than HDPE.