That is a big help for my install today! I think I got the new kit with rubber pucks but the instructions have an update stapled to the outside of the install guide that still wasn’t clear. Especially since they had a diagram of a jounce support and a lower support bracket in the original install guide.
@cbravo2129 ай бұрын
Thanks for the details in both these videos for the airbags.
@mjsz28429 ай бұрын
Thanks for this video. I want to use this kit on my truck, but with taller blocks in the rear of my truck, I wasn't going to be able to use those little support brackets, but since I have the jounce supports I should be good.
@jhoward16693 ай бұрын
Agh, they change the 2625 kit again. They change the lower spring bracket. The slot is even shorter that needs to potentially share the airbag bolt and the lower support bracket if you needed it.
@LowOnCash7 ай бұрын
Thanks for the update about how many inches does the bag raise the rear. I want to install the kit on my 550 RV and I need to lift the rear to get up my driveway without scraping. Thanks Mike
@Poweredby8Racing7 ай бұрын
I’ve never measured. But I can visually tell a couple inches easy.
@LowOnCash7 ай бұрын
Thanks do you think they would fit a F 550 or does Firstone make a kit for the 550 Thanks Mike
@Poweredby8Racing7 ай бұрын
@LowOnCash no idea… :/ they are very helpful and knowledgeable though so if you shoot them an email I’m positive they will get you squared away.
@jonathanm52707 ай бұрын
I have both brackets. I like the original longer bracket and I welded stops on it so it can't come off the bracket. Just 1/4" tabs on each side of the puck keeps it from sliding. I then drilled 2 holes and put a u bolt on under the jounce bumper so that the bracket doesn't want to lift upwards near the leaf stack. The center of my bolt into the airbag is right at the edge of jounce bumper so it's aligned. I went through everything you did with tech support and what they tell you to do still isn't a great design. There shouldn't even be a slot it should just have a single hole so it can't move. Also the spacer puck is a must not sure why they didn't think of that from the beginning
@jordanhuff2894 ай бұрын
Dude! Thank you!!!!
@capitenjimmy2 ай бұрын
dit your u bolts on the truck got twisted ..? im not sure if that it will cost any problem ..
@Poweredby8Racing2 ай бұрын
No, none of my bolts are twisted.
@capitenjimmy2 ай бұрын
@@Poweredby8Racing do u have the torque numbers of the bolts of the lower bracket
@Poweredby8Racing2 ай бұрын
If I remember I just did them tight
@hhazelhoff1363Ай бұрын
Extremely confusing video
@jhoward16693 ай бұрын
That is a big help for my install today! I think I got the new kit with rubber pucks but the instructions have an update stapled to the outside of the install guide that still wasn’t clear. Especially since they had a diagram of a jounce support and a lower support bracket in the original install guide.