F4U Corsair 5 3

[@mikecousins1]

what is he cutting with the hot knife ? and where are the files for the little tabs ???

[@tacticalbacon8064]

I wish they would've add some details to the model like rivets and body line also the outer wall could be thicker for durability sake even if its heavier and cost more to print i could survive a harder landing if it was a little more solid

[@jordyb323]

What size printer do you need for this, looking at buying one for my rc hobbies and came across this, looks mint

[@craiggreasley7071]

when can i buy it !!!!!!!

[@kkuenzel56]

Are you printing with PLA? When I have used CA accelerator on PLA it seems to attack the plastic.

[@garybennett6032]

where do one get the locating tabs to reinforce the fuselage, I cant find the files to print

[@vincents1303]

I have the same question. Thanks in advance.

[@vincents1303]

I asked to the support ➪ The file is called sure bond and is in the wings folder :-)

[@MonsterPartsRc]

You should use a hot cutting knife... I have a USB powered one specifically for cutting 3D printed parts that works great... Please make a smaller version too... I can't fit this anywhere!

[@snaprollinpitts]

What color did you use, it looks like a deep blue, but not quite? thanks looks great, gotta get one, or make one?!!!

[@robjohnson8522]

I ended up using Gizmo Dorks Dark Blue. Looks good. Available on Amazon if you are in US

[@rolandbenner3861]

Try Filamentum PLA Extrafill "Cobalt Blue" it prints fantastic, the color is as in the video. Print temperature without fan is 220°C, bed 55°C. I always print on glas with 3DLAC spray on it.