factory :laser alignment

[@Pritest72user-sz3zg9px2q.]

Transparent is good to watch and learn, thank you..😊🙏

[@barkster]

I would love to know where to connect remote momentary switch for the pulse.

[@mutohprdproduction8828]

is that a plastic you covered the corner of lazer tube the rwd one.

[@farouqiamin7894]

Can you please do a video on how to adjust the focus length when using 1.5, 2, and 4 inch lens? I know the machine comes standard with a 2inch lens but when I put in the 1.5 lens its constantly just makes a large size circle when the laser fires almost 3-4mm

[@MilanKarakas]

At 8:36, this is not a 'diagonal adjusting screw', this is mirror pivot point. Don't touch that unless you want to shift whole beam.

[@jinanqualitycncmachineryeq5536]

hi, thank you for your response, we ll improve it soon

[@amitfernandes4367]

Thanks for this video. My mirror alignment is good except for the last vertical alignment. Instead of a circle my laser is a crescent moon shape. Very very thin. Any advice?

[@azzfame]

Thanks carol

[@amitfernandes4367]

Thank you for the reply. I ended up having to remove the entire laser head to align the final mirror because it was so badly misaligned like you said. All is good now. Thanks again Carol!

[@jinanqualitycncmachineryeq5536]

hello , how about your lens,sir? are they all right? no broken ?

[@gaby26jbl]

Hi Carol. My name is Gabi and I'm from Romania. I have a big problem, I can not make alignment with a 60w laser co2. the laser beam comes out of the laser tube as it should. what do I have to do to get that point? please beautifully HELP ..

[@mutohprdproduction8828]

hi carol thanks for the video my lazer tube voltage cinnector the one you covered with red cup. i covered it a rubber tape is that correct? any advice please

[@jinanqualitycncmachineryeq5536]

hello , please use the red cup together with the tube , this is with high-voltage

[@MarkSchuster-ym3iy]

I am installing a autofocus on my RUIDA laser and am interested in using a proximity sensor instead of the special made laser sensor which is made up of a proximity sensor and a metal button that as it touches it gets closer 4mm to the sensor. Can you make a video as to how you setup the proximity sensor ?

[@bonplan92]

hello Mark, so finaly you find the way to put this sensor , i'm have one on 3d printer and bltouch too if we can mount one like this is a dream , thank

[@cesarpelayo3799]

How do you make an extended pulse button?

[@cesarpelayo3799]

Carol zhu can you teach me where to tap the wires?

[@amxen1]

i love water bubs

[@evanwinn372]

Hi, When I get laser in center of third mirror then move laser head far away it is not center. I center it and then move laser head close to second mirror it not center. How do i center both?

[@Pritest72user-sz3zg9px2q.]

😊😀🙌💪👌💞💕

[@TopCutCNC]

Can i contact to you

[@noctician]

bonjour impossible pour moi de régler la machine je les acheter en chine si tout aller bien je devais acheter une 100w mes comme la 50w n est pas réglé et personne pour m aider je ne les pas acheter la 100w si une personne peux m aider a réglé et faire fonctionner la mienne je serais ravie part la suite en acheter une autre donc je suis preneur pour avoir de l aide

[@helenpeters5534]

Please how do I reset the Datum of a laser machine?

[@ukstarvideos]

I want to In hindi learning