FASTWAY SPARK ARRESTOR HOW TO INSTALL

[@ericdaoust4940]

I'm not sure what others were expecting but took me all of 10 mins to remove my old end cap and install the new one.. perfect fit! Looks great.

[@mbraun777]

Thanks for the video. I would have totally forgotten the RTV.

[@AZRickD]

I installed mine yesterday. It would've been nice to have some basic directions. Such as: what size drill bit to make the pilot holes. I had to eyeball it, and probably used a bit one size too small, but I was able to use a drill/driver to send the self-tapping screws go in (very tightly). No mention of Locktite on any of the screws (no directions, again).

[@promotobillet]

Our apologies if the Instruction decal was not on your Spark Arrestor package. An email or phone call directly to us could have also helped you immediately. The decal points you to detailed instructions for most of our products: fastway.zone/howto/#sparkarrestors

[@human1513]

Same here no instructions came with it in 2022. So glad for this video.

[@human1513]

@@promotobillet Spark Arrestor for KTM, Husqvarna GasGas, PBM-01-3112 not listed at that website. I have this part in my hands now. I have a 2022 KTM 300 XC TPI

[@HMBRSTN]

Bought February 2024, still no instructions included

[@Jack-by2hg]

Would a 7/32” drill bit work? That’s 1/64” bigger than you said in the video

[@Jack-by2hg]

Do you need to do any tuning after you install?

[@michaelwood5519]

Thanks, got one on order!

[@promotobillet]

Awesome, we hope that you enjoy it!

[@richardramos9799]

They should have angled the tip down more so you dont melt your turn signal like I did on my 2009 450 exc.

[@promotobillet]

Hi Richard, thanks for the feedback. Our end cap nozzle angles similar to most OE mufflers, but could use some added angling on certain applications. We do have Silent Turn-Down Inserts (PMB-01-0011), Ultra Silent Turn-Down (PMB-01-0012) or even a Side Shooter Nozzle (PMB-99-0015) that could alleviate your concern when using our Spark Arrestor End Cap. Thanks again for sharing!

[@michaelosullivan8288]

Nice video and would they able fit on lexx mxe and what other exhaust do they fit on cheers

[@nickfraser2891]

Great concept, But the final appearance looks rubbish. If you made it look like one piece and took the hard edges out of it you would sell heaps more. ''Just saying''!!

[@0475Mike]

What a joke, I had to take a mallet to mine to make it work. Not happy w fitment. Took over a hour to just make it fit.

[@robertlaube574]

Sounds about right, guarantee this took him an hour or so as well.

[@ericdaoust4940]

Took me 5 mins , few taps of a rubber mallet and fit was perfect could not have been easier , and it looks flawless

[@ngzcaz]

Where is the USFS stamp ?

[@promotobillet]

It's typically laser etched on each applicable Spark Arrestor base.

[@gkling33]

Seal a cone

[@promotobillet]

I see what you did there! :-D

[@adamwinters9576]

Pain in the ass....smh

[@promotobillet]

Are you having issues with an install that we can help with?

[@adamwinters9576]

promotobillet I got it...was just a pain drilling out all the existing rivets in the stock end caps...thanks though