FG MARDER Part 5: Engine

FG Marder engine pull start cover, kill switch, air filter cover, screw change, etc.
Forget to mention I rotate the pull starter 90-degree clockwise before this video.
#rccar #rchobby #rc #fg #zenoah #2wd

[@lynnslifelessons4242]

New from Shorty's , Thanks for sharing

[@jukkaovaskainen]

Thanks very much for watching 🙂

[@15scalercgarage76]

Very nice setup going to look good in the fg

[@jukkaovaskainen]

Thanks very much for a comment and watching 🙂

[@cyclonerc1625]

Nice work Jukka. engine looks Sweeeet 👊💯🍻

[@jukkaovaskainen]

Thanks, and thanks for whatching 🙂

[@ug1166]

Hj nice video What size screws did you use to mount the engine and clutch and where can i buy them from Many thanks

[@jukkaovaskainen]

I just change screws to hex type so I can use my hex handtools for all screws of the Marder.

[@VlogGoals]

Hi superb video, stay connected! 👍

[@jukkaovaskainen]

Thanks, and thanks very much for watching! 🙂

[@islandrc-duke1972]

Great video and work

[@jukkaovaskainen]

Thanks very much my friend 🙂

[@Serialcrasher]

Nice. Did you rotate the pull starter handle by 90 degrees ? Mine was initially heading towards the back of the car and was rubbing the cardan shaft when running 😱

[@jukkaovaskainen]

A very good point!! 👍 I turned on the pull starter as soon as I got the car and forgot to mention it. 😕 Shouldn't forget to mention things like that.

[@Serialcrasher]

The only disadvantage of doing it is that you must then remove the body to start the engine. But is it a rather small one, as this kind of engine run for very long period on one tank, and usually don't stall 😀 I am waiting for the Beetle body presentation 😁😁😁

[@jukkaovaskainen]

@@Serialcrasher Yes you are right, when orginal body is on, it's easier when pull start is where it was in first place When using beetle or Fiat etc. bodies, rotate 90 degrees clockwise is easier. But like you said when you start the engine it runs forever. 👍 Body video will be maybe one or two videos after, but don't expect too much, especially for the paint job 😆

[@JOHND_RC]

Nice 👍🏼

[@jukkaovaskainen]

Thanks a lot for watching 🙂👍