Field Target Tech Episode 19 STEYR REGULATOR DISASSEMBLY AND SERVICE

In this Episode of Field Target Tech, disassemble an LG 110 FT regulator, inspect and clean the internal parts to correct the pressure fluctuations I was having.

[@victorflores9058]

Eres un crack amigo, me funciono super bien en mi steyr, estaba todo irregular, pero ahora ya constante solo 5 fps de variación. Muchas gracias por compartir

[@s.abbasmohseni4841]

Thank you very much ❤️

[@sach548]

Thanks Sir .

[@sniperxbow60]

Ivo, Yes you are correct. This was only a quick disassembly to clean it, at the time, I did not have a regulator tester, and did not want to tear the whole thing apart. I have since gotten a regulator tester, and have torn it completely apart and rebuilt it. I will do a follow up video where I go into the entire rebuild process.

[@blessedhellride1531]

As already said, you didn't completely strip the regulator. The shuttle needs to come out and you probably should have replaced the seals also. Without a reg checker you also don't know what pressure it now functions at, if it recovers quickly after a shot cycle, if it creeps in pressure over time, etc. This is a video of how to do a half assed job unfortunately.

[@ivoaldimirov9375]

Hi mate, you actually are doing half of the job. You did not pull the piston out of the body to clean it and it's O-ring and lubricate after cleaning. Believe me there is a plenty of dirt that is formed there by the aged grease under pressure. The way you only sink it in alcohol is worth near to nothing - the dirt stays there.

[@vaibhavtandon2924]

Dear Ivo, Can you ease help me how to install springs in the regulator because i forget how to install. I need your help on this metter. Thanks

[@ivoaldimirov9375]

@@vaibhavtandon2924 Hi, the way the spring washers came out is (())(()). However I put them in the following order: ()()()() This is the way it used to be in old production regulators and gives more constant velocity results.