Finishing what Barb wire Pasture Fence I have 1st 4 to 6 wire.

[@brandonhoad9033]

Couple strands of 'lectric so much easier. But barbed is easier than American

[@LudasGarage]

I bought some 15.5ga hi-tensile because i thought i would run some of that, but man i cannot work with it. It always wants to return to it's original form.

[@brandonhoad9033]

@@LudasGarage that might be what's here, untouched. It's like trying to use rod, so stiff.

[@LudasGarage]

@@brandonhoad9033 Exactly how this roll is! I went to buy some brace wire, and that is what the lady recommended since the brace wire was on back-order. I tried to use some; it about pinched my fingers after i had wound it up and took a hand off. Luckily i had cutters in my back pocket!

[@brandonhoad9033]

@@LudasGarage and ya have to almost stand on them to get it cut. Just a thought, but y couldn't ya use some chain instead. Bit costly but at least it can be worked w. Lil turn buckle in the middle, should work it seems. Hopefully tomorrow the rain stops so I can put chopper back together and get going again. Bearings for blower hub and lots of repaired or replaced metal in the housing. No part untouched actually.

[@LudasGarage]

​@@brandonhoad9033 I guess you could use chain. There was a brace wire #9 shortage around us last year. The supply chains seem to have gotten better, it has always been in stock the past few times, I went in. Yep its about time to start running crops.