Fino Edge Knife Sharpening System Upgrades

DOWNLOAD FILES LINK:
www.thingiverse.com/thing:502...
Upgrades designed by Leading Edge at :
www.thingiverse.com/thing:413...
I also built the "Leading Edge" system available for download at the above address :)
Check my video of the Leading Edge system here:
• "Leading Edge" Knife S...
---------------------------
My only issue ( easily corrected) with the Fino Edge system ( see at end of the video ) is that the screw that holds the vertical rod in position at times may come loose during sharpening and the rod slides down a tiny bit lowering the sharpening angle ( it happened a couple times )
I will make the grooves on the flat portion of the rod bigger/deeper so the screw bites more solidly into it to prevent this from happening.
For now I am putting two or three ball bearings inside the main housing to bring the angle close to what I want and then I adjust/fine tune with the top screw/holder. It's actually working very well that way with no fear that the angle may change.

[@Sdelaj_sam_KH_UA]

Прикольный конструктор ножемана. Отличная работа.

[@vincentjoseph5726]

Sweet little being small hobbyist... knives sharpened tools..i try someday making one similar situation required for knives sharpened

[@burtjoubert]

Great video and nice setup!

[@cellodan6353]

Hi Burt, in the comment above Rafael would like the files for the upgrades

[@bostjanbizjak3952]

Top work

[@Houndicon]

do you sell the upgrades?

[@cellodan6353]

The designer has made the upgrades available for free. The link to download the files is in the video description Cheers 😊

[@nine971]

天才

[@rafaelrubalcaba1553]

Where can I find those upgrades?

[@cellodan6353]

Go to thingiverse at www.thingiverse.com/thing:4135236 and ask the designer "LeadingEdge" for the files. Alternatively I can email them to you if you provide me with an email

[@burtjoubert]

I'll upload my design files for it to Thingiverse. Should be available for you to download in a day or two.

[@rafaelrubalcaba1553]

@@burtjoubert ... thanks for the quick response and I was asking about the upgrades because I was actually thinking about getting that same specific sharpener

[@burtjoubert]

I've uploaded the design files to Thingiverse, but for some reason KZbin does not allow me to post the link here in the comments. I'll email the link to CelloDan and ask him to add it to the description of this video. Search Thingiverse for the following design number in the search field: 5025060

[@cellodan6353]

Hi Rafael, here I am posting the link for download that the designer just sent me, cheers :) www.thingiverse.com/thing:5025060

[@NicMALINA]

на 00:47 видно огромный люфт держателя клинка. В помойку станок

[@DA-jw6nm]

Stainless is not magnetic enough to be trusted

[@siriosstar4789]

These type of systems suck . they are slow and tedious and the stones that come with them are terrible.