First 10 Things to Check When Your Round Baler Goes Down

[@billybobs841]

Good video bud thanks

[@westbamafarmer]

Great video! What size is them chains on a 5x6?

[@billybobs841]

I use a temp gun to check 4 bad bearings

[@neilfreund7523]

Great information. Where can I get one of those Bale Trak Pro Code Cards? Thanks.

[@billybobs841]

I gota question 4 ya i got a jhon deer 5083e and it dash is on KM instead of MPH how do i get it back to MPH??

[@edbloch180]

How about some information on Older John Deere balers 330,430,435

[@billybobs841]

Wat u Wana know about them

[@chantellthedford1805]

My 466 will not feed the net its not rap up any where was working amonth ago any ideas

[@berniewatts7598]

Not sure you will get this. If you do here is my problem. 467 jd baler net wrap issue. On occasion a bale will be wrapped numerous times beyond what it is set at. Finally stops wrapping with no error codes sent. Any ideas what causes this?

[@dansievers5915]

I got a 456 silage special. Unfortunately sometimes the net is wrapping around one of these rubber rollers in the back of the baler. WHY ?

[@WesternEquipment]

A lot of time this happens if the rubber roll is not completely smooth. If there is a cut or nick, or maybe ever some built up material on it sometimes the net will catch and start to wrap around it.

[@backcountryfarmer24]

Our 569 baler is set to 67 inch bale but makes oversized massive bales and I get oversize alarm everytime what can I do

[@jackalopegto]

On my Bale Trak Plus, you push the "bale diameter button" (2nd button from the left on the bottom). Then, use the +/- buttons on the bottom right to adjust larger or smaller. 🙂

[@backcountryfarmer24]

Our 569 baler is set to 67 inch bale but makes oversized massive bales and I get oversize alarm everytime what can I do

[@billybobs841]

Adust the bale size sensor