fitting a rev counter on the lathe

[@grahameblankley3813]

Very good informative video, marking the lock rings for the spindle is worth doing, soon after I purchased my new lathe it came loose good that I had marked it clearly!

[@TheKnacklersWorkshop]

Hello Alan, Nicely done... I will look forward to watching the video on the new motor and VFD.... Take care. Paul,,

[@andrewdolinskiatcarpathian]

Excellent work Alan. Must do similar for my Myford Super 7. 👏👏😀👍 Andrew

[@MrScienceMaths]

Excellent work👌, Love you Enots

[@enotsengineering]

Thanks a lot!

[@paulmeynell8866]

That was great thank you

[@TrPrecisionMachining]

good job

[@Blackcountrysteam]

Good vid think you should have mentioned that the Hall sensor only works with one face of the magnet normally the south pole on my set up I use an old mobile phone charger a good power source !

[@enotsengineering]

Sorry I did mention it in the previous video checking the lathe speed

[@kimber1958]

Great work

[@davidharris5736]

Thanks Allen. Very enjoyable could you post a link to the parts for the rev counter? I would be interested to do the variable speed motor installation too. i have a boxford but the motor has been changed to a 240 volt that is underpowered, so it wont run under load at the higher speed. I suspect the gear ratio was changed too. Will a .75 hp motor bee enough? I suppose we will find out.

[@enotsengineering]

Hi David I purchased the part from Banggood I have asked them to send me a link.

[@DK-vx1zc]

excellent!

[@eded4944]

Battery box Battery 1,2,3,4 ?

[@wilkbilt]

This has nothing to do with this video, but did you ever find a way to reduce the number of decimal places on your DRO

[@enotsengineering]

No I did not find a way to reduce the number of decimal places. Does anyone know if you can alter the number of decimal places.?