Fitting and Testing my own K40 Air Assist Feed //Upgrade

The Air Assist for a laser engraver blows a jet of air down towards the point where the laser beam hits the material being cut or engraved. The intention is to blow away any particles of that material that have been vapourised. This leaves the path clear for the beam.
The upshot of this is that the beam cuts through the material quicker and it doesn't get scattered by or ignite the smoke that is generated.
I found a number of nozzles on Thingiverse for my K40 laser, my favourites being the ones with the jet that comes in from the side. The problem I had was that, after printing a couple, i couldn't fit them to the laser head without unscrewing various parts of the machine. This isn't a problem (I have a screwdriver) but it then leads to the need to check the calibration of the mirrors that control the laser path.
In the end, I took a couple of "Things" and remixed them to create www.thingivers...
This can fit onto the laser head with or without an M3 nut and screw. It just depends on how tight a fit you want.
You can feed a length of clear aquarium tubing (amzn.to/37clu4j) into the hole on the side and I took the opportunity to hook this up to a cheap aquarium pump.
I'm really happy that I decided to add this as my first upgrade and I hope this video helps you understand how much an effect it has.
Let me know in the comments if you download the free model from Thingiverse, I'd be interested to hear your experiences with it, or feel free to contact me on any of these social links.
/ tinkerneering
/ tinkerneering
/ tinkerneering
You can support this channel by liking or sharing videos and by subscribing too.
Don't forget you can sponsor this channel at Patreon.com and get early access to all my content. / tinkerneering
Your support in any form is very much appreciated.
Thanks for stopping by.