Fixing a 2 Stroke Pipe! 2 Stroke Pipe Repair!

[@ianh3007]

Stash is on point

[@highlandcycles]

Hahahah. Thanks man

[@prospectorsoils1240]

Real torch and run circles outside to in. Like magic. Been doing it for 20 years. Emphasis on real torch.

[@highlandcycles]

I know. Just don’t have one and this works fine for this.

[@jacobworld333]

Do you have a video where u need to bend the pipe to fit?

[@richardhartley7094]

The only way to get the dents out but does look just a little risky 🤕👍

[@highlandcycles]

#safetythird

[@richardhartley7094]

@@highlandcycles 😄👍

[@Danman1972]

How did you tweak the flange so it fits better? I just heat and use a broom stick or pipe when pinning a mount of the floor with my foot. I put a old beach towel down to keep it from scratching. Any easier way would be great. Also, suggestions of beating bark busters back into submission?

[@highlandcycles]

It just went straight with the heat and air. I didn’t have to tweak it at all. I was surprised. As far as bark busters, I have a 3 ft crow bar

[@johnfavre1987]

What happened to the hydraforce ?

[@highlandcycles]

I still use it for some pipes. It just depends on the kind of damage.

[@onemoreride9376]

Morgan is that a universal clamp kit, if so what brand is it?

[@highlandcycles]

It is. It’s from Mino MX. They are on eBay

[@highlandcycles]

It is. It’s from Mino MX. They are on eBay

[@onemoreride9376]

Thanks man, hope to see you in late Aug

[@hello-dirt]

Is this the kit you used on my GPX TSE250 pipe? I would love to try this on the new pipe before the dents get too large, like they were on the previous pipe.

[@highlandcycles]

It is the same one. I need a hotter torch for that steel I think.

[@highlandcycles]

It is the same one. I need a hotter torch for that steel I think.

[@highlandcycles]

It is the same one. I need a hotter torch for that steel I think.

[@kevinbroadway5398]

as far as vanity that sucks buy a nice new fmf or pc nickle plated, i like to walk by and rub my pipe w some wd40 feels soooo goood

[@highlandcycles]

Hahaha. Not that vane. I do have a beautiful one on my 125 race bike though. This bike is the work horse

[@kevinbroadway5398]

@@highlandcycles i have the same horse but i just got it took the old fmf pipe off it sold it for 180 bought a nice new shinny one for 220 so for 60 bucks more i get the horse w the vain

[@jeffcheezbalz7045]

my 2 stroke is easily strait piped

[@prospectorsoils1240]

What are you paying for part time fab guy with real tools?

[@highlandcycles]

Not much. Can only charge about $40-50 for a repair