Haseeb recommends alternating between the legs when soldering the IC to prevent overheating of the chip. Nice troubleshooting!
@forevertechenglish Жыл бұрын
Hello Dear what do you mean by alternating between legs?
@bobsoft Жыл бұрын
@@forevertechenglish Do not solder the legs beside each other. That will create a lot of heat in one area of the chip. Go back and forth between sides of the chip as you solder. I forget what video he mentions this in. This video below demonstrates how he solders IC's. kzbin.info/www/bejne/d3y8momZmKyEepI
@kjabojet442 Жыл бұрын
Good work you make it very clear thank you very much 11:40
@phillypheeling Жыл бұрын
Nice troubleshooting 👍🏿
@phallatep2274 Жыл бұрын
My mother board is same as your mother board the red led near the CPU is showing normally the relay works fine. I tested with insert 220v the fan working but the compressor is working only 2 seconds and stop. The red led light on the motherboard start to blinking faster. I face to this problem with few motherboards and I can't be fixed it. Do you have any idea where should I continue to check? Thanks for your sharing the knowledges.
@PrinceAdewale-p7c11 күн бұрын
thanks master
@kualalkuolom Жыл бұрын
THX!
@forevertechenglish Жыл бұрын
Welcome
@alighasemi36888 ай бұрын
درود مجدد برا استاد گرامی خداوند منان را بسیار شاکرم که من در زمره کسانی قرار میگیرم که بخت یار من باشد و شانس انرا داشته باشم که با چشم خویش ببینم هنوز هم چنین انسانهایی در زمانه ما زندگی میکنند بدون هیچ چشم داشتی امیدوارم برای وقتهایی که اینجا میگزارید 10 برابر پاداش دنیوی و اخروی انرا در زندگی شخصی خود و خانواده محترمتان دریافت کنید
@ebrahimh6658 Жыл бұрын
یه برد جدید میخریدی بهترنبود متاسفانه درکشورمن قطعات برد واردنمیشود