DIY Welded Metal Workbench

[@BrandonLayMusic]

Great job mate!

[@glennfowler5223]

Great video will use to make my own work bench. Thanks

[@johankralt5318]

It turned out great! very nice. Thanks for sharing. Greetings from Amsterdam.

[@Mrdcq]

I am new to welding and I am about to make a workbench similar to the one you have made good video Thanks.

[@DawnBriarDev]

If you don't trust your own welding (like myself, also an amateur welder), then a tip: After checking square, tack weld each corner before going in and fully welding them. This way, you can mitigate the risk of overheating and bending things out of square while fully welding the corners.

[@RobotDrivingACar]

You should fully tack the entire table in this instance, checking squareness in each stage. After it’s all tacked then fully weld it. Helps prevent distortion etc.

[@gk6993]

Nicely done.

[@mikecoughlin4128]

How thick is the metal plate and is that thickness working out for you or would you change it next time?

[@harlech2]

Always remember, as AvE says: "A grinder and paint make you the welder you ain't!"

[@danjaluvka8007]

whats the thickness of that metal plate, when beaing supported by a mdf board? just curious, if it could be as little as like 1,5 - 2 mm and still being quite stiff

[@stevevorpe5735]

Traduire en Francais.Mercie

[@usarmy500]

If you are stick welding than you don’t need to clean the metal up first only with mig welding