Fluke 289 Repair Leads connected incorrectly

[@thomasjensen7962]

My Fluke is working again after re-soldering. Thank you David Fisher👍

[@omerosman6651]

Thank you so much for your informative video. My Fluke 289 meter had the same diode you mentioned come off. luckily, I found it inside the unit and was able to solder it back on the board, the meter is now working fine.

[@jeppler3]

Thanks a bunch dude! My LED had come off and was stuck to the bottom of the clear plastic where the leads plug in. I would have never seen it (very tiny) or known what to fix if you didn't make this video. Gotta love a free repair!

[@ravivel7720]

Thank you chief, I repaired it asper your video 😊. you saved my meter

[@bartomiejkaminski3139]

Hi. I have the same problem with my 289. I was looking for possible reason and I found your video. Thanks. And best regards.

[@cgmwoodworx]

Good to know that error drives me nuts.

[@kregerstainer]

I have a bad super cap(leaking) what is its model and specs

[@alfredo4310]

Hola, soy de Chile y quisiera saber si solo se requiere puentear el sensor derecho o también el izquierdo, yo realice un puente en ambos sensores, pero ahora el instrumento me descarga las pilas, aunque no lo utilice.... agradecería muchísimo si puede responder a mi consulta... saludos cordiales

[@amindavid11]

l no "puenteo" nada, lo que hizo fue resoldar el sensor como va

[@nejdetsungur715]

Thank you so much

[@abrarahmed3268]

Disply not working

[@northwestrepair]

I was told fluke is the best. I was doing some research for fluke meters like this one with graphical interface and what i learned is that FLUKE is GARBAGE.

[@michaelakmotrikova6356]

I just bought a fluke 289. I am horrified what a piece of crap!!! Without the backlight on, the display is unreadable and dark. Even with the lighting on and the contrast set to maximum, the display is blurry and bad! I must be an idiot for buying this junk.