FLY WING Bell 206 RC Helicopter - 4 vs 2 Bladed Rotor GPS Flight Modes Comparison 🇸🇮

[@jeffkraus1457]

Andrej, did you make any adjustments to the throttle control in the software program with the 2 bladed upgrade? Also, why do you not recommend the 2 blade mod for GPS flight? Thank you.

[@emsman59]

Thanks, Andrej for making this and all your informative videos. Did you say you're flying the 2 bladed Prop setup with a 4s 2200mAh battery due to its lighter weight? Also FYI, probably due to your extensive testing videos, AliExpress and FlyWing are now selling the FlyWing Bell 206 with 2 Props, not 4! Better realism according to their site but my guess is a pretty big cost saving to FlyWing! Anyway, thanks again for all you do for the RC community and me!

[@AndrejSturm]

Thank you 😊 Yes, I was using a Turnigy Nanotech 4s 2200mAh 35-70C Lipo because it's not as heavy as original. Interesting, thank you for that info 👍

[@emsman59]

@@AndrejSturm Is this Lipo a 3 cell or 4 cell?

[@Soryt]

Nice video , could you adjust te gain of the swashplate to get less occilation ? Noise with 2 blades is a lot nicer and looks better .👍👍🚁

[@AndrejSturm]

Hi Soryt, unfortunately the FC is very limited and the only gain you can adjust is the tail gain. I have flown with the 4s 2200mAh Lipo, so the CG was not perfect (a little tail heavy), so I repeated the test (not in the video) with the stock 4s 4450mAh Hv battery and it was a little better but not much. Yes, much less noise with the 2 blades 👍

[@RCREVIEWS101]

Spot on, the tail electric motor noise is annoying with the 2 or 4 blades, we can clearly hear the flight controller making corrections and the electric motor winning up and down. I have the UH-1 with a lemon GPS module or H-1 FC, does not hold steady and keep on turning it off. If I was not used to fly without the GPS I had it crashed in the first flight.

[@did3d523]

best noise quiet with 2 blade ! more aesy to transport

[@icqjackie]

I like the conclusion!

[@Damyang69]

Good flight..

[@AndrejSturm]

Thanks 😊

[@sven-ingeblank9863]

How to buy a 4-blad rotor?

[@Damyang69]

Can decrease noise from tail motor ?

[@AndrejSturm]

How to lower the tail prop noise (3 steps): - first modification: kzbin.info/www/bejne/jJSzealresuAg5Y - second modification: kzbin.info/www/bejne/pXi6qYBphNdnnqs - third modification (upgraded tail motor): bit.ly/3jj0eCm

[@mankwee]

@@AndrejSturm Hello the third link is dead. What where the specs of this motor please ?

[@MuhammadImran-qj9nk]

From where i can buy it.. any website

[@AndrejSturm]

bit.ly/3Doy9Bn

[@ernestdyer9401]

How. Much

[@bronkokulitscka8837]

Sound is better with two blades😅