Flycolor ESC for Boat setting

[@ijanmotoclubijanmotoclub9039]

I follow u setup its easy to program tq sir 🎊🎊

[@paulcooper7162]

Hi i followed your instructions and set up was easy.

[@PLANETHELITV]

The off position should be on the neutral position of the trigger ( center) , so what you do is (after binding is done), switch on the TX, pull trigger fully (don't let go) , connect esc to batt, wait for two beeps, and let go to neutral position, wait for the rest of beeps, its done.

[@עומריחנינה]

Can you make the motor rotate only by using that Wi-Fi module connected to the app, without the receiver and controller?

[@reptiloidx8942]

DOES THIS PROGRAMMER CAN SET LOW VOLTAGE DISCHARGE LIMIT FOR BATTERIES OF 36V-48V ??? BIG THANK YOU

[@vaneulinh2]

could i use this to start the motor without remote, for testing motor?

[@kaeboz6985]

can you reset esc without the programme box?

[@BWWGL9]

What size WIRES are on the 90A ? also, where did you get the Program Box from ? THANKS

[@mahesapemuda6750]

That's good!

[@nickloucura]

forward e reverse ( Bidirectional ) When pushing the throttle inti reverse sem card. Apenas transmitter

[@user-sj5hl4yw5t]

А карта с ним идет

[@johnhuber4965]

good job mate thanks

[@gesssteel6784]

Bang pake bahasa indonesia aja