Ford Collision Warning Radar blocked and Adaptive Cruise Control not working.

[@stevebrain65]

Still working great after more than a year!!

[@pureluck8767]

Wont the glue block the sensor?

[@ekoko3]

Thank you, I have a Lincoln MKT 2011 and faced the same problem, I only replaced the grommet part number W790214-S300 and the sensor returned to work, thank you for being the reason, I only spent 7 dollars to fix the problem,😘

[@marklinford2400]

I had the exact same problem, but I end up taking the whole front bumper off to fix it. Thank you for posting this video!

[@noahnajor2408]

I’ll try this, been bad for 5 years on my 2015 mustang GT! Cruise control doesn’t even work. Error message comes up of course. I’ll try it! Thanks again!

[@MB_84]

Thank you! I have a ford ranger wildtrak 2018, and this solution works for it too. I used stainless steel wire🙂

[@user-oc2fg3jr6d]

Thanks for this video I will try to fix it in your way

[@bargz1]

thanks for the video -- this fix worked for me!

[@jonycreche2731]

Steve I just bought a 2012 edge my sensor was loose I pushed it forward and put the Weldon as you suggested. So let me ask you a question on how should this work, every time you come close to a vehicle should that red light in the windshield go off and second will the brake apply automatically?

[@pllevine01]

So you used JB Weld over a mounting screw for your ACC sensor. You best pray that you never need to replace that sensor.

[@tanyapalmer3617]

i have 2019 f-150 and i have this error that the pre-collision sensor is blocked cant figure out where it is to try to unblock....

[@switchingearsgarage648]

Did you find it?

[@EricEvolving]

Great video

[@jessesward9429]

I had this light come on after replacing a brake switch. I unplugged the brake switch with the car running which caused the light to come on. I cleared the codes in ABS and in the engine and the cruise control light went away

[@MyName1sJ3ff]

I know it's been a while since this video but I had the same thing, did the same thing and the Cruise is working and the collision sensor is working also. But, the error keeps displaying on dash when car is started. Does the Collision sensor need to be cleared and re-programmed by Ford? Thanks

[@ThornEternal]

Does this cause the car to drive rough? This just popped up, and immediately after the car started driving rough

[@trishporter123]

I have this problem on my 2021 ford edge titanium and ford told me it was a bird and a rock

[@dancook4993]

I have a Lincoln MKZ doing the same thing no error message but I think it’s the same issue just have to find it how did it work out for you ?

[@topofidahotravel]

Snow blocks my collision sensor

[@mbarka1980]

I have a 2017 Toyota Camry Xle model. The car is not are equipped with pre-collision and lane-departure system . today days ago after I derived the car in heavy rain, the warnings light for the pre-collision and lane-departure system is on. Has anybody else been having problems?

[@usfederalgovernment]

😎

[@christianhalla3905]

You didn’t repair anything.

[@bigbrother5797]

Yep, just snap it back on, Phil Long Ford wanted $500.00 to fix while the ranger is still under bumper to bumper warranty, they didn't honor their fake warranty I fixed it myself for free in less than a minute