Man you picked the perfect vehicle for content. I'm forever working on my edge
@danromeo65715 жыл бұрын
Good video. Try doing the AWD. What a piece of work Ford came up with there...
@charlesjohnson87944 жыл бұрын
All you need is remove dust shield use the rotor threaded hole in the old hub run a longer bolt threw and a metal block and you can push it right out .
@The_Muthias5 жыл бұрын
Thanks for the tips. Took a few hours of pounding. Had to use mapp gas so it took a while longer
@nicksmith50534 жыл бұрын
Thank you for " adding in " about the awd, solid mate!
@jeffreysenior5 жыл бұрын
Anti-seize is my friend to. I use it also where the spindle shaft goes though the bearing, and I mix anti-seize and Greece together to lube up my caliper slider pins also.
@jacobnovick56564 жыл бұрын
One trick that can work for this is dual air hammers, spinning the bearing back and forth. Takes two people, heat and penetrating fluid as well.
@tamishagraves48095 жыл бұрын
This task is principally applied for all of the Ford vehicles or is this universal process that can be used on any vehicle your repairing requiring wheel bearing hub removal ?
@eliassilva62715 жыл бұрын
Hi, I'm Elias from Brazil, Sorry to post here to your channel. And I have a problem with my ford edge 2013 that no one will find the defect. she walks the straight but appears the message CHECK AWD. and when I pivot the rear wheels seem to be braking, it locks to the point of holding the car.
@tamishagraves48095 жыл бұрын
What tool is that your using to pry out bearing there is it a slide hammer thats used to pull dents out ????
@Thebunholio5 жыл бұрын
Is this the same for the front wheel drive on a 2007?
@creepycrawler46905 жыл бұрын
Evidently people are scared shitless to make a video of replacing the drivers side rear cv axle on a 06-10 awd ford edge. Absolutely no information anywhere.
@andymartell37045 жыл бұрын
Informative as usual Bill..
@mikenorton73235 жыл бұрын
are the hub assy. hub182 the same for front and back for my 2011 ford edge?
@charlieryan17365 жыл бұрын
Thanks for another helpful video 👍🏻
@tabauknight7 жыл бұрын
That looked like a real tough job. What would that cost in a shop? Good job!
@TheOutwiththeold4 жыл бұрын
38210 Hub Removal Kit for Dodge,,, try this next time...