Ford Mondeo MK4 2.0TDCi 85KW 2009 Charger intake hose replacement / Výměna hadice plnícího tlaku

How to change hose from intercooler to air intake on Ford Mondeo MK4 2009 TDCi 85KW (Intercooler Air Hose Pipe, Turbo Intercooler Hose, Turbocharger Hose) / Výměna hadice plnícího tlaku z intercooleru do sání
Pn: 24SKV783
OEM codes:
1383684
1430292
1459397
1468764
6G916C646F
6G916C646FB
6G916C646FC
7G916K683AA
www.forum.ford-club.cz/viewtop...

[@stephencumming9735]

Great video my c max had issues low performance turbo lag changed pipe back to full power check this first before a garage

[@djmikee71]

Great video just what I needed thanks

[@seanmaynard8208]

Great video thank u for that I have to do the same pipe for my wife's ford smax

[@marekcziba3178]

Thank You Dziękuję dałem radę

[@marklong6701]

Would this be the same on a Ford kuga 2009 with same tdci engine to get to the bottom screw behind bumper for clearance

[@Placekmich]

Hi, unfortunately I dont have any experience with Kuga, so I cannot tell...

[@MalcoDude]

Did this hole cause a loud whistling when accelerating, I think if so I have the same problem? Thanks

[@Placekmich]

This hole made grey smoke behind car. For whistling I would recommend to inspect hose directly from turbo.

[@MalcoDude]

@@Placekmich brilliant, thank you 👌

[@Smallshock]

Hey, have you solved your problem? I might have the same issue.

[@Bavenbushcraft]

Fantastic video. Was there a film of engine oil in the old hose? I hear this is quite normal.

[@Placekmich]

Yes there was oil. I think it is normal, but if there is a lot of oil, it could be signal that turbo is broken.

[@salangen321]

Did you Get engine malfunction light from the Hole in the hose?

[@Placekmich]

Only when I travel longer time up to the hills. Then I stop the engine and red sign was off with the next start. After replacement this was solved.

[@bigdaddywild]

Yes turbo boost pressure sensor

[@SS-ul4oc]

Поляк?

[@jamesredfern999]

Where does the zip tie go? Mine doesn't already have one.

[@Placekmich]

The zip tie just holds two hoses together - nothing more. I think that this is not necessary to have it there (just my opinion).

[@jamesredfern999]

@@Placekmich thanks. I did mine today as it was split on both ends of the pipe. I couldn't get to the clip on the intercooler end due to its orientation so had to go from underneath. Used a similar part to you. The ford plastic ones are rubbish.

[@sedatbc6390]

What kind of problems does the car have before changing the hose?

[@Placekmich]

Hi, the problems were with grey smoke behind the car and engine malfunction sign when a drive up to hills in cca 3-3,5Rpm. After turning engine of and starting again the engine malfunction sign disappeared and diagnostic was without any DTC stored. DTC was readable only when the sign was lighting.