Ford Racing Puma IB5 Gearbox Basic Service, Clean & Paint

Ford Racing Puma Gearbox Service.. On this video I'll clean this down, remove the insides of the gearbox, then give the casing a more thorough clean and paint. Then I'll re-assemble the gearbox changing the Spring, Selection seal & Boot, also the 5th Gear Housing Gasket.. This is a kind of a once in a 10 year job to do and great for cleaning out the gearbox properly and filling up again with fresh oil... Also I'll change the driveshaft oil seals too..
Hope you enjoy the video

[@TheSebas83]

Hello, i just bought a 2002 mk1 focus with 1.8 zetec-e engine, the car was sitting since 2019 and i have a grinding noise in first gear, it goes nice into all gears, a bit stiff clutch and shifting gears but i presume is normal after so many years not been driven, regards.

[@autotechnical6996]

Very nice 👌 and x pireans super

[@joshuabrown9398]

Did you change any of the bearings? They become noisy on higher mileage cars?

[@Harryd06]

Is this a strong gearbox

[@lionelkef5446]

How did you do that with the yellow bolts? Is that new ore refresh?

[@allisonautomotivediy8088]

new Bolts were used... Yellow Zinc Plated ..Regards

[@norbertkrasovski2427]

Is it same garebox which goes in 1.7 once too?

[@allisonautomotivediy8088]

@@norbertkrasovski2427 essentially yes... but with a tweaked final drive / Shorter gear ratios for quicker acceleration in the lower gears..

[@norbertkrasovski2427]

@@allisonautomotivediy8088 so servicing is the same on the seals?

[@donjones7083]

Where are you based, hard to find any trust worthy gearbox technicians. Need someone to swap my final drive on an IB5 box

[@rodfrancis9160]

My mechanic said the gearbox is sealed and the gearbox oil can't be changed.Is he wrong?(Puma 1.7 Y reg)

[@SmeurkeDeKat]

IB5's don't have a designated drain plug and are claimed to be sercive-free for life. Nobody that I know of takes that seriously though. Popping out one of the driveshafts will drain the oil. Filler plug is an allan-key bolt inside the plastic housing on the front of the gearbox that holds the shifting cables. Full level is around 10-15mm below the edge of the filler fole. It's not advised to use the hex-bolt below the filler plug as a drain plug, as it holds the detent for the shifting mechanism.

[@allisonautomotivediy8088]

Yes he is.. :)

[@Vyper5]

@@SmeurkeDeKat hi, thanks for sharing your experience. What quantity and type of oil you need? 75w80 is good? Aprox. 2 Liters? I think is the same gearbox on a 1.0 ecoboost 140hp fiesta black edition ? Thanks

[@alexandr488]

Вой в движении при нагрузки ford c max 1.8 мкпп ib5 поменяли все подшибники, а вой так и не пропал, вой на всех передачах бросаешь газ на передачи вой пропадает