Hello, thanks for the video. My Dexta was similar, hard to start. In my case it was losing prime. Perhaps before going too far with a rebuild you could investigate the lift pump and rebuild that. Might save you a heap of work. Cheers, John
@rumpoh80398 ай бұрын
THE WORN TEETH WILL STILL DISENGAGE UNDER LOAD. YOU WOULD HAVE HAD SAME EFFECT WITH A BUNGEE HOLDING PTO LEVER FULLY ON. INSTEAD OF ALL THAT WORK. I IT IS NOT FIXED WITHOUT BOTH GEARED PARTS REPLACED.
@E300B Жыл бұрын
I just did rings and bearings in my dexta it had the same issue it was a prick to start cold the biggest problem I had was getting the precombustion chamber caps to seal properly
@giacomoramon111510 ай бұрын
Mio zio fratello di mia mamma ha un ford dexta uguale al tuo. Lo ho guidato molte volte ed è molto veloce in terza penso che raggiunga la velocità di 40 chilometri orari veramente bello. Saluti dall'Italia.
@danielbeiersr3642 Жыл бұрын
How are the hydraulics on your tractor, it’s been the weak point in my Dexter for years, 40 years ago I tried to rebuild my hydraulics system and all that was available was a seal/gasket set which didn’t help much!
@rossm7734 Жыл бұрын
I have no problem with hydraulics. It lifts front wheels of the ground no problem