Forklift Repair - Yale 3K Forklift Won't start

  Рет қаралды 14,972

Travis H

Travis H

Күн бұрын

Пікірлер: 60
@jimlloyd8792
@jimlloyd8792 Жыл бұрын
Good morning Great videos I just purchased a 1978 yale 3000 pound lift capacity forklift all new to me. I checked the fluids. The oil in the transmission. Fluids were very milky. I replaced the oil and filter just had a question about the location of the drain plug for the transmission fluid. I believe it’s between the forks underneath the transmission. It looks like it’s an Allen head screw and also the location of the fill plug I believe its on top of the I transmission under the floorboards, just trying to verify that thank you for your time
@hcr-motorworks
@hcr-motorworks Жыл бұрын
The fill plug should be under the floor. its removable and should get you a better view as to where the hydraulic pumps/tank vs transmission and engine are. The drain plug should be on the bottom of the pan. Be careful getting underneath these heavy beasts!
@jimlloyd8792
@jimlloyd8792 Жыл бұрын
Thank you for the input one more question I seen your video working on your distributor cap so when I start my Hilo it starts up and then it stalls out. It doesn’t pry four or five times and every start up unless I keep my foot on the pedal to keep the RPMs up, I have been adjusting my idle, but I don’t want to keep it too high I did change my spark plugs. I did look through my distributor cap and rotor. Hit it with some super fine sandpaper to clean everything up. Would it be worth it to go ahead and buy distributor cap rotor and wire or was cleaning that up be fine I think this hilo sat for a while that’s why the oil and transmission fluid was milky. I’m not sure what the condensation would do that distributor cap and rotor. That’s why I was reaching out to you. Thanks advance.
@hcr-motorworks
@hcr-motorworks Жыл бұрын
I would absolutely replace the cap/rotor/coil/condenser. Mine had the same problem, would constantly flood and not start unless you had absolutely fresh gas and a full battery. Now it can sit for a year or more and be started with ease.
@rickmavictime756
@rickmavictime756 Ай бұрын
Didn't these have Mazda motors?
@grantmorris4221
@grantmorris4221 4 жыл бұрын
I gotta very very similar forklift can you plz put a pic of the ignition the color code and diagram is impossible to find and if I ever do find it its gonna be impossible to understand
@hcr-motorworks
@hcr-motorworks 4 жыл бұрын
Are you looking for the ignition key wiring diagram?
@renes1419
@renes1419 Жыл бұрын
Is possible to get part number of the ones you order or if you can tell me what engines it has
@hcr-motorworks
@hcr-motorworks Жыл бұрын
If you pause the video @6:25 you can see most of the boxes of parts with the part numbers for what I replaced in this video.
@jimlloyd8792
@jimlloyd8792 Жыл бұрын
Good morning I have another question for you before I changed out my rotor cap coil I lost spark I did change out my rotor cap coil condenser and I still have no spark. Any suggestions thank you.
@hcr-motorworks
@hcr-motorworks Жыл бұрын
I'd make sure your getting power to the components first.
@CanonCam
@CanonCam 3 жыл бұрын
I think we have the same fork lift... what year and model is yours? I can't figure out what I have but it's looks identical.
@hcr-motorworks
@hcr-motorworks 3 жыл бұрын
I want to say this one in 1970 something but most of the data plates are worn down and hardly legible.
@joeheilm
@joeheilm 3 жыл бұрын
Thanks for the forklift videos! Do you happen to remember what voltage regulator you used? I noticed you had 2 on the bench....i am struggeling to find the right one for my gtc040 yale/mazda fe. Cheers
@hcr-motorworks
@hcr-motorworks 3 жыл бұрын
WVE 1V1088 was the one I ended up using from Rock auto. Not saying its the correct one as I'm still having some grounding issues with that unit but it does work and charge when running which is more than the old one was doing. hope that helps
@leandroramos7402
@leandroramos7402 3 жыл бұрын
Hey! I have the same forklift, I bought it second hand and don't know nothing about it. Could You Say me wicht year was manufactured yours? Thanks
@hcr-motorworks
@hcr-motorworks 3 жыл бұрын
I wish I knew. Most of the data plates are worn to the point where they are unreadable. Most of the engine parts I've gotten for it though are from a late 70's and early 80's mazda truck. You'll just have to do some digging to find out what engine and parts interchange will work for your application.
@gjames57
@gjames57 10 ай бұрын
Is that a gas or diesel? If gas what engine? Thank you
@hcr-motorworks
@hcr-motorworks 10 ай бұрын
Its a gas, its a mazda or Isuzu 4 cyl. I forget which exactly
@hcr-motorworks
@hcr-motorworks 4 жыл бұрын
Buying ANYTHING from AMAZON??? Click any of the links above and then go buy WHATEVER YOU WANT!!! The shop will earn a tiny commission from whatever you buy! It doesn't have to be the actual product on the link!
@Panelson74
@Panelson74 3 жыл бұрын
do you have any wires going to the alternator lug terminal? if so how many?
@hcr-motorworks
@hcr-motorworks 3 жыл бұрын
one lug and one four prong plastic clip. If your having charging problems its most likely the external voltage regulator though or a fuse under the dash area.
@Panelson74
@Panelson74 3 жыл бұрын
How many wires to the lug?
@Panelson74
@Panelson74 3 жыл бұрын
Some one had put a cs140;on mine trying to one wire it.
@Panelson74
@Panelson74 3 жыл бұрын
I am going to put a transpo 951 on it
@Panelson74
@Panelson74 3 жыл бұрын
Solid state regulator
@bobsmo7869
@bobsmo7869 4 жыл бұрын
What engine is that. I need a new distributor for mine
@hcr-motorworks
@hcr-motorworks 4 жыл бұрын
Mine is a Mazda UA engine, but you'll have to check the model and serial number on your machine to be sure as these forklifts had multiple manufacturers supply various powerplants through the years
@Panelson74
@Panelson74 3 жыл бұрын
Why 2 box's of spark plugs?
@Panelson74
@Panelson74 3 жыл бұрын
Looks like acdelco and champion box's?
@hcr-motorworks
@hcr-motorworks 3 жыл бұрын
@@Panelson74 Im not sure actually, I think I ordered one of each just because I've had issues with spark plug fouling and wanted extra on hand in the future.
@jimlloyd8792
@jimlloyd8792 Жыл бұрын
I don’t think it really matters, but my forklift runs off propane that doesn’t matter does it
@ourv9603
@ourv9603 3 жыл бұрын
SO, you don't troubleshoot a problem you just throw parts at it until it starts? !
@grantmorris4221
@grantmorris4221 4 жыл бұрын
Btw I subscribed so be cool
@hcr-motorworks
@hcr-motorworks 4 жыл бұрын
Thanks for the Sub!
@Panelson74
@Panelson74 3 жыл бұрын
Need the complete parts list, does you're alternator match this one? www.amazon.com/Quality-Built-14194-Premium-Alternator-Remanufactured/dp/B000ES8KTQ
@hcr-motorworks
@hcr-motorworks 3 жыл бұрын
I'm not sure if it matches exactly but yes it does have a four prong clip as well as a lug on it.
@Panelson74
@Panelson74 3 жыл бұрын
It does mitsubishi 35 amp.
@bobcat8439
@bobcat8439 4 жыл бұрын
Watch all that for nothing 👎
@hcr-motorworks
@hcr-motorworks 4 жыл бұрын
Ya Win some, ya lose some. If you wanted to see it run here ya go! kzbin.info/www/bejne/jJ64hJxtj9pgiZY
@timmart5991
@timmart5991 4 жыл бұрын
About all you can get for a used junk forklift is scrap value you'd be better off just scrapping it
@hcr-motorworks
@hcr-motorworks 4 жыл бұрын
sadly in today's world that seems to be the going consensus with most things. If its broke chunk it in the dump and buy a new one. I prefer to fix things if possible :) Thanks for watching!
Dynamat EXTREME Sound deadening installation
12:08
Travis H
Рет қаралды 11 М.
BAYGUYSTAN | 1 СЕРИЯ | bayGUYS
36:55
bayGUYS
Рет қаралды 1,9 МЛН
“Don’t stop the chances.”
00:44
ISSEI / いっせい
Рет қаралды 62 МЛН
UFC 310 : Рахмонов VS Мачадо Гэрри
05:00
Setanta Sports UFC
Рет қаралды 1,2 МЛН
10 WORST EVER Car ENGINES!
7:58
Auto Insiders
Рет қаралды 1
Kioti Tractor Clearing Woods - are you insane
20:27
Travis H
Рет қаралды 8 М.
Mounting the rear SMC valves on Kaydees Mazda b2200
24:49
Kentucky The MiniTruck State
Рет қаралды 245
Datsun 280z - Zinc plating parts
11:07
Travis H
Рет қаралды 1,1 М.