Рет қаралды 25,936
This video shows a complete, easy to follow tutorial on how to wire a "FORWARD AND REVERSE MOTOR STARTER", from beginning to end.
One important thing to note when wiring forward and reverse motor control is to ensure a means of interlocking the two contactors, so that both contactors will not close at the same time. this is important because, the reversal is achieved by interchanging two lines at the out put of the contactor and if both contactors close at the same time, there will be a short circuit between the reversed lines.
There are two ways of providing the interlock: Mechanical and Electrical.
In this video, Electrical interlock is used.
I hope this video will be beneficial to electrical engineers, technicians, electrical trainees and many others.
How to build automatic changeover switch: • AUTOMATIC TRANSFER SWITCH
Automatic changeover switch Part2. • AUTOMATIC TRANSFER SWI...
• STAR DELTA CONNECTION
• Star-delta starter |Co...
• HOW TO WIRE AN 8PIN TI...
• HOW TO WIRE A TIMER TO...
• How to interlock two c...
• how to connect 3phase ...
• Complete wiring | Auto...
• AUTOMATIC TRANSFER SWI...
• 3phase motor winding c...
• How to check for open ...
• #1 Contactors explaine...
• AUTOMATIC TRANSFER SWITCH
• #1 Direct-on-line Well...
• #2 Direct-on-line cont...
• OVERLOAD RELAY CONNECT...
/ @obloni_electrical