FPV CAMERA NOISE PROBLEMS TROUBLESHOOTING

[@RDM-RC]

Thanks bud for the info! Great Job!!

[@highwaymen1237]

Put the camera and transmitter a separate battery.

[@VetteWay2Fast]

Yea I had a cam hooked onto my tug and those things run so hot and the range was pretty poor. Ended up ditching it, I’m sure the high end ones work better but not wanting to speed that kind of money on it. Hopefully you get it running good!

[@highwaymen1237]

How many milliwatts is your transmitter? You may want to do the testing outside away from Fluorescent lights and wifi. If you're walking away from the receiver, the water in your body will absorb the signal.

[@JANDRMARINE]

@@highwaymen1237 the camera has a built in transmitter of 200 MW

[@highwaymen1237]

@@JANDRMARINE That should be plenty of power. A lose antenna or mismatched or wrong length antenna can be a problem. Operating the transmitter and reciever on a frequency as close to 5.8GHz can help. Having the reciever very close to the RC transmitter can be a problem.

[@mad_lizard]

Couple things The added fans could be causing the video issue interference. Awesome maybe the quality of camera you might have On my personal recovery craft similar to what you have I don’t have this issue I run a separate camera to the transmitter so it’s not a all-in-one system, cooling on transmitter I robbed a cooling heat sink from my old dynamite 120, zip tie those two together, and then used a small 5 V water pump to control the heat off the transmitter. ESCI don’t have a problem with 850 KV motor 12 x 3 master air screw propeller on 4s