FPV Part 9: FPV Hardware Overview and Placement on SkyWalker Plane

[@RcBuddy]

Nice, you got allot off work to do ;o) Bear in mind, that a servo or something els could go dead on you and you have to replace it, but you have it covered so I see.

[@AkanMeister1]

Regarding flying vehicles, I read on myrcmart that compass should be placed far from power and motor sources to avoid magnetic interference. I noticed that you intend to place the compass at the middle/top of frame, but you didn't say where the energy sources would go. I am guessing at the bottom of frame, and I am wondering if these distances are safe?

[@DaveMerc]

+Marko Jakovic It's been working great for years. No problems with acquiring and keeping satellites or with the compass.

[@matheus4455]

Hello Demerc Nice build, I`m biuld one like this one, what is the length of LRS Extension?

[@DaveMerc]

+Matheus Leite Matheus RMRC 60cm (2ft) SMA Female to SMA Male RG316 Extension SMAMF60CM

[@yellowbluerc5047]

Next time its better to put the receivers with each other (gps and rx)and putting the telementry with the vtx because you put the rx in the back then a telementry and then gps vtx so the listeners are very close to the talkers wich creates intervearance sorry fir my broken english but this is key to small fpv systems and good but not key for bigger ones

[@DaveMerc]

Actually it works great the way it is. Could be because the telemetry is only 100mw at 915mhz while the EZUHF receiver is 433mhz, no problems.experienced.