FreeCAD for Beginners #51 Angular Sketches

[@casualcomputing]

Will not the TNP come into play when you include the edge from the model in the angled sketch?

[@Adventuresincreation]

I don't believe it will but that is a good point. I will test it and let you know the outcome.

[@Adventuresincreation]

I just tested it and indeed you are right. - Changing the model breaks the location. I would have to locate it using math and create the placement long hand. I hadn't thought about that to be honest. It does make the inclusion of geometry problematic.

[@rudolfzaris675]

Thank you for your videos. This content s very important here on youtube .

[@Adventuresincreation]

Thanks!

[@SMDUGGAN1]

A bit off topic, but can you share the math to determine the angle of 56.32 deg? I'm assuming you're using the tangent function but unclear for which angle.

[@Adventuresincreation]

You are correct tanX = O/A bear in mind I started with the plane at 90 degrees

[@stevelevine1868]

I don’t see a subscribe button.

[@Adventuresincreation]

Are you already subscribed? - That's very odd.

[@noanyobiseniss7462]

INTRO way too loud!

[@Adventuresincreation]

Thanks for the feedback

[@zorabixun]

How it happened the hols are going through and escape on the edge ? I have watched the vid few times, but there is not a moment to explain how they go through up to the edge ?

[@Adventuresincreation]

When I create the pocket (hole) it says through all and symmetrical. This will cause it to go directly through the entire model and thus to the edge.

[@zorabixun]

@@Adventuresincreation , sorry but the holes can go anywhere through the box I guess the holes are linked to the plane going at an angle to the opposite edge, so this is guide them where to go .... thanks