FreeCAD: New Unified Coincident and PointOnObject tool.

[@sillonbono3196]

When I noticed this "unification" on the 1.0 RC I just went into the toolbar and added the old coincidental constraints into my toolbar, I prefer that they are separated if for any other reason than "being used to the old way" stubbornness.

[@ajarivas72]

Beautiful video.

[@johnclark3648]

When I tried this new tool in Freecad 1.0 on three lines, it worked ok. When I tried to make two circles concentric, I received an error 11304. No error on doing the same in Freecad 0.21.

[@4axisprinting]

I hate using this phrase, but it works for me. But I'm sure if you can create a simple sketch where the error happens and attach it to an issue one the FreeCAD Github, it'll be looked at.

[@johnclark3648]

@@4axisprinting I fixed the error. Problem was related to having FreeCAD 0.21.2 installed and installing FreeCAD 1.0 on the same laptop. Using FreeCAD 1.0 to draw a simple two circle sketch and use the Coincident tool to make the circles concentric on the origin gave the error. Uninstalled FreeCAD 0.21.2 and FreeCAD 1.0 worked fine on same sketch.