Freewing 64mm 4S F9F Panther V2 Unboxing | Motion RC LIVE

Join Wes and Lori for a live unboxing and first look at the new updated Freewing 4S F9F Panther. These have just arrived into stock and we cannot wait to see what the new updates have in store.
Get yours here:
www.motionrc.c...
-----------------------------------------------------------------------------------------
New merch is available here: motion-rc.crea...
Want to see your pictures or video in the show? Share them on our Hobby Squawk Forum here: bit.ly/MRCLiveS...
#rc #motionrc #live

[@braddarnell2498]

Wes, my tail bottom was two pieces but it took me a minute to figure that out. I believe you did it the hard way lol. Once I saw it came apart it was a breeze to get the pushrods ran through the holes.

[@incubrian]

MOST important part of this entire video, esp if you're flying futaba and arent getting throttle at all= go to 54:10

[@incubrian]

quick update, on Futaba, you'll hear two beeps, go to full throttle, then 3 beeps then back down, and then get ready for the model to jump into wide open lol. but at least the throttle channel works.

[@sanexup1038]

Ordered one right away! Super excited! Wish it were a 90!😊 But I'll be getting the 80mm Cougar.

[@russshanks5913]

Nose cone SHOULD have been magnets only. Love that the canopy is latch held now and wider fuselage! I have old one and always use landing gear...if you don't use the gear, the reverse thrust is almost no use.

[@michaelbaskin7821]

Picked one up and tried my spectrum receiver in it ,didn’t work out to well😂 glued her up and I’ll try again

[@Acicchetti21]

I converted mine to a 4s doing that battery mod and upgrading the ESC a few weeks ago.

[@chrisr4274]

Got my Panther Friday. Put it together. Found the CG 1 3/8 from leading edge. Seems very tail heavy with the battery all the way forward. Seems like I need around 2ozs if weight in front. Does that seem right. Afraid to maiden it. Any one else notice this?

[@michaelmickoberhaus8009]

What about the weak points where the intakes meet the fuselage?

[@markkremnitzky3911]

Wish it was available in EU!!

[@billj1585]

No removing the paint before gluing parts together?

[@russshanks5913]

I was thinking the same thing...takes time to sand those small places too.

[@incubrian]

my v1 panther is like a decade old and still intact. never sanded the paint. although i did use epoxy.

[@txkflier]

Should have been an 80mm..

[@oldmandoingstuff8997]

IF it were Free The Flying, Trolls wouldnt want to pay shipping. U get what u pay for players. We Low $$ Flyers love the Bank an YaNks

[@chrisr4274]

Got my Panther Friday. Put it together. Found the CG 1 3/8 from leading edge. Seems very tail heavy with the battery all the way forward. Seems like I need around 2ozs if weight in front. Does that seem right. Afraid to maiden it. Any one else notice this?

[@russshanks5913]

I'll bet the landing gear would help???