Freightliner cascadia Spn 91 fmi 8 accelerator pedal position data problem detected part1

Freightliner cascadia pedal replacement
T40 tool
Screw size M8 - 1.25 x 35mm
If it gets to difficult to take off the bottom screws you can just break off the old pedal because its plastic to make it easier
• Freightliner cascadia ...
• SPN 91 FMI 8 PART 3: P... for more info regarding shop work for harness

[@TATEXPRESSINC]

Shoutout from TAT Express out of Hutchins, TX

[@MrCadillac919]

Thanks for video I just had this to happen 1/3/23

[@EASTCOASTIMPERIAL]

@ 395 What was happening why you changed the pedal??

[@MDPvideo1]

kzbin.info/www/bejne/aqLKi2B7n7J1Ztk

[@saieddastan4721]

Hi thank you for sharing this nice post .i have a question about this alarm spn 91 fmi 8 on cat engine ecm .i found that this alarm mean chanel accelerator pedal signal missing but i cant reconize that problem refer to ecm either pedal or wiring between them

[@laronirvin3138]

Did your check engine light come on when you got that code on the dash the shop is trying to tell me it’s my CPC

[@MDPvideo1]

kzbin.info/www/bejne/aqLKi2B7n7J1Ztk

[@sergior5552]

Did you have to replace the nuts on the engine side? Or was it good just with the bolts from the inside?

[@MDPvideo1]

Just the inside

[@sergior5552]

@@MDPvideo1 Appreciate you! Thanks

[@quintgallow4882]

say problem rn change pedal code still showing

[@MDPvideo1]

Tell your mechanic to check and test the wire harness

[@quintgallow4882]

@@MDPvideo1 they dianogse it being a bad CPC Moduel.

[@TTuckerTrucking]

Where did you get your used CPC

[@AndrewsD2]

You have to change the cpc when the pedal goes out right? I’m having this problem right now and I’m thinking it might be the cpc

[@MDPvideo1]

kzbin.info/www/bejne/aqLKi2B7n7J1Ztk

[@kemosabeusmc]

Did it work ?

[@MDPvideo1]

Yes but a week later I had a wire harness issue i had to replace at the dealer cost me 4 stacks

[@kemosabeusmc]

@@MDPvideo1 I'm dealing with a cpc issue currently, hoping it gets resolved asap.

[@MDPvideo1]

@@kemosabeusmc hang in there...hope all goes well

[@kemosabeusmc]

@@MDPvideo1 I dont have a choice but to hang in there. Good luck to you as well