Friction machining on the lathe, is it worth it?

Hi guys, I made this video to show that it is not always possible to obtain valid results on the first try... If we consider this type of processing, it is possible to work well with thicknesses no greater than 2 mm and diameters no greater than 40 mm.
I hope you enjoyed the video, if you want to stay up to date, subscribe to the channel and put a like!
THANK YOU

[@Massimo68ac]

Normale procedere per tentativi! Lo speciale è perseverare e fare il risultato, come lo hai ottenuto tu! Complimenti👍👍👍👍✌✌🤗🤗

[@lucasandri5462]

Molto interessante, bel video!

[@Masters.of.101]

How is it possible to draw 18 gadge stainless-steel pipe if it is possible to draw please make a video as possible by the way nice work dear

[@claudiovandoni7878]

In ritardo ma bravissimo come sempre

[@user-mq8uv9zq3x]

Very nice video and technique. I wonder if the tube was pre-heated with oxygen- fuel torch if the tube seam stay intact.

[@newtech5042]

Hi, I didn't preheat the tube, the friction of the tool is enough. As far as welding is concerned, these pipes are actually difficult to work with (not counting the galvanization), it is much better to work with non-welded pipes.

[@user-ys7qf6vc4p]

А чем Вас самокал не устраивает? - и да, - для таких целей, резец ставиться выше центра!

[@lucasandri5462]

Molto interessante, bel video!