FrSky ETHOS Stabilized Receiver Temporary Lua Script Install on PC Windows 10 ARCHER TANDEM TWIN

[@stevenmohr4588]

Thank you!

[@dfrost42371]

If possible, could you do a video on setting up a momentary switch for a thrust reverse feature? Many ESC are coming out with a reverse signal wire. I am using a X18 and SR8....Thanks

[@eoinj3929]

At 2:53 you say we should see the following 2 scripts available but the screen image isn't clear enough to see and you don't give the file names. Pity !

[@frskyben]

Hi sorry about the resolution not being clear, the two scripts should be installed as such : scripts\SRX Cali scripts\SRX Stab

[@FrskyService]

great stuff!@@frskyben

[@stephen_adams]

I configured my first Plus SR8 and the toggle is not turning the Gyro on/off. It is ON by default. I reset the RX and completed the setup a second time. Same Issue. I had a 2nd SR8+ RX so I set that one up as well. Same result. They default to ON and CH14 is not turning them OFF. Any ideas. Thanks.

[@frskyben]

Have you updated the firmware to the latest version ? Can you verify the firmware for the receiver by having it registered and bound, then go to the Gear Icon \ Radio Setup - Info page and let me know what version it shows for the RX1

[@aegidiomoresco5982]

My ex 20 Pro won’t put the SRX calibrate and stable next to the information icon in settings on my Transmitter so I cannot enable the stabilization. I have the 2.06 Scripps in my file manager Radio receiver still on I’m running boot loader 1.4.15 RF module is V one.1.13. Radio is up-to-date with 1.5.9 any suggestions

[@frskyben]

Check again that you have them installed correctly into the scripts folder. They won't load unless you have them in the correct location

[@aegidiomoresco5982]

Do I have to make a script folder and what would happen if I reset to factory settings

[@frskyben]

@aegidiomoresco5982 yes if you don't have a script folder you need to create it. Tbh I'm not sure what all the factory reset will affect I think it just resets the radio customized settings but doesn't touch model files or scripts

Is there a way to turn off the stabilizing function for all but 1 channel? On some of my planes I only use and want stabilization on my rudder.

[@frskyben]

With the latest firmware yes you can set all channels to aux mode which is non Stabilized normal channel output. So you can leave just the rudder to Stabilized output. The new firmware requires reset and reconfiguring the Stabilized Receiver including rerunning calibration and self check by removing the receiver from the model

Great, thank you!

[@frskyben]

i should note it is only supported on the newest stabilized receiver lines, TD, TW and ARCHER Plus -- not the older stabilized receivers