Full car audio install in a Mustang

[@bradp5107]

I can watch the amp board building process ALL DAY. Awesome. I also feel for Fernando. I did the sound treatment in the trunk and back deck of my 21 Sentra. Very tight spaces. Not sure how you can do this all day, Everyday. Every time I see you doing this it makes my back hurt just watching. Great job Everyone. Keep up the hard work.

[@JoseGarcia-wl3im]

I fell you. I did the whole trunk on my 300 and boy a sweat 😅 my a.. off.

[@AzraelIgnis]

I personally feel every single vehicle should have a 3 way setup from factory. But that's just the audio enthusiast in me.

[@polarberc1]

One of my favorite installations, so clean! Wish there an installer as good as you guys in Sacramento where I live.

[@yel0n_s550]

One of the best Video about audio in Mustang I have ever seen! I really appreciate that you share this knowledge with us, thank you! Great job, Regards!👏🏻👏🏻👏🏻

[@silverjava1one971]

Great content. Like how you explain everything and how it all works together.

[@stutterbox36]

Fernando is such and important part of the team

[@kyleyoung2720]

greetings from Trinidad. love seeing you guys work

[@K.B.E.B]

Dean is the Amp board building 🐐. Fasho!

[@specsbundy1392]

Love watching your install videos .. one day I hope to learn these skills .. can you do a video and compare the sound quality of Focal. Audio Frog, Dyna Audio and Morel speakers.

[@JacesOwnWorld]

Just buy Audison’s. They’re better than all the brands you listed.

[@gary-qn7wu]

Hi Dean, came across your video very informative, I'm gathering all the parts and pieces to do the same on a 22 stang, I'd like to see a vid on just you making the harness with a bit more detail before I butcher my wires! ,seems that no one makes a plug&play harness for my car great vid. Gives me some definate ideas how I will do my system

[@mehdibensaid5796]

awesome, many thanks for all this content

[@Bobbrians]

With a laptop, a bluetooth odb connector and a program called Forscan you can switch the factory programming of the headunit. You can shut off factory EQ and put the hu in amplified or non amplified mode, bit of research required but very useful when installing in newer ford vehicles.

[@smurfeco2.358]

The dsp fixing that issue and it's definitely worth it

[@mikeodell5915]

Thanks guys ...great video as always

[@Sup3rPat]

Nice video! I considered upgrading my Mustang as well but ending up deciding not to because my exhaust would just take away for the sq

[@johnsmith-qz4bv]

great video guys on to the next one

[@gerardosalmeron83]

Like always another winner video Fernando your awesome

[@coyote5.046]

Does no one do a dsr1 in these cars be a great video I know I speak for a lot of people. Hey dean anyway we can get a full install with a idata dsr1

[@williamh6547]

Awesome work 👍👍

[@iwilliex]

Great Job, so clean.

[@dempseyodickson2856]

Sweet install 🔥🔥

[@zolomad3359]

Can you make a video of the 2014 mustang with a shaker system, please!!

[@_NIGHTFURY_5.0]

Have you had any luck ?? im trying to do this with my 2014 Mustang Shaker 500 system as well

[@johnny_playz_beybladeunbox8458]

You guys are the best. By any chance do you have any install video on a Toyota with jbl system where you install kenwood dsp or Rockford dsr1 I’m want to make a install on Toyota Sienna 2018 with jbl system

[@jaytrnst]

You guys are such professionals i wish i can dring my mustang to you. I watch the entire video I just would only get 1 subwoofer and custom box

[@johngajewski4276]

Professional job where are you located and how much was that job

[@ahmed2ndable]

I know kind of a old video, but I'm hoping for an answer to an issue I'm having with a similar build I'm basing off this video. I'm running audison apk163 for the 3 way and audison apk 6.5 for the rears, had a old unused polk audio d400.4 amp for the speakers. I wish I was able to get a t- harness for the signal wires, but I live in Bahrain (small island in the middle east) and these things are impossible to get here. so I had to tap into the wires as you mentioned at about 12minutes into the video with RCA wires and plugged them directly into the amp. for some really bazar reason as soon as plug in the RCA the amp trips into protection mode and keeps tripping. I'm pretty sure those RCA wires are wired correctly because I also have an old 2 channel mono Kenwood amp laying around and when I plug the RCA into that all is good and sound comes out of the speakers. any ideas why my polk audio amp is tripping like that and not taking the signal? could it just not be the right amp? or its damaged somehow?

[@ronjefferson4261]

Love this channel. Question on the speakers. I'm install a AP4-FD21, and a 5 channel in it. Does this go through the amp as well or does it bypass the amp? I want to get the best, flattest sound possible. I've been out of car audio for ages so it scares me lol

[@InstallersAssistant]

Just curios regarding the amp rack.... why you hid most of the wiring underneath, but left the power cable, and crossover cables visible?

[@KruszkaBonzo]

Perhaps a silly question - but why go around those holes with moisture barrier and not cover it completely with that butyl foil?

[@ZealousDragon]

So, you bypassed the OEM amp? And in doing so, did that remove the preconfigured EQ curve?

[@dennisjames242]

I have a 2016 mustang gt premium with the same shaker system. How much did the system cost? you can pm if you need to

[@kenrain404]

Would be cool if you add the cost of the complete build on these videos. Love the content

[@Eastsideadventures]

By any chance do you guys have those plugs for sale? I haven’t been able to find one

[@davesway1170]

Quality work. Good to see professionals on youtube instead of a bunch of pretenders

[@p2rt]

Wait, my understating always was that when you run 2x750w subwoofers, then you are going to need 1500w mono amplifier, but the amplifier (lc-1.800) you are running is only rated 800w and you are using two subwoofer, what I believe are 750w each. What is the deal with it?

[@sas281gt]

Somehow I missed you fixing the roll off for the highs and lows. Or did I go get the laundry at the wrong time?

[@undrgroundperformance]

Whats up Dean and Fernando

[@adamwaters9]

Is the additional battery acting like a capacitor for the system?

[@eurly93]

Can someone explain the point of using a T-harness? It seems like doing that would send the low level signal from the radio to both the factory amp AND the new amp. Why not just bypass the factory amp entirely? I'm getting ready to do this install on my mustang, and I cannot figure out how front and rear signals get combined into only Left/Right inputs at the LOC.

[@logielogful]

I have a 2023 and I was told there isn't any way I could get amps for subs and component speakers ?? Is this true I have the 9 speaker system with 8 inch touch screen

[@frobi6852]

One problem with this install, there is no fuses between the second battery and the amps so nothing to protect from shorts

[@junito1008]

These guys are the best !! I’m planning to drive from NY all the way to Florida just to have you guys to do my car’s audio…do you do quotes by phone?? I want to have an idea of how much I will have to spend.

[@vcjester]

Just remember that labor rates are X. If you want to hang around and watch, the rate is X x 2.

[@junito1008]

@@vcjester No…I don’t want to watch !! 😂 I have KZbin Premium so I’ll watch the installation on KZbin with no commercials. 😁

[@jordanfraser8201]

Has anyone ever told you the 5 star logo looks like a funny looking lion? I cant un-see it now

[@leo101827]

does this work the same way for the 2012 mustang gt with the navigation radio

[@jackharrison4327]

Is there a way to add a front camera to the 2020 mustang with the b&o audio system?

[@stupit1679]

why didnt they need a line output converter?

[@smokey8764]

I did my premium mustang and when I have the door close and rev the gas pedal i hear engine noise in the sub but if i open the door and rev it i wont hear it any suggestions?

[@christiandshatto7765]

And,,,,,- YOU DID BUY A MUSTANG!!!👍🏼👍🏼😁

[@smokey8764]

Where do you located?

[@michaelrobison8572]

Did you use an isolator relay for second battery

[@dougmacrae9535]

Does the Crysler 2016 200 have an amplifer?

[@rickdodson5252]

But wait!!! Dean, you did buy a mustang...lol!!!

[@knull1320]

If the customer ever complained about fueling issues after this install, just scroll to 40 minutes in. Yikes!!!!! I cringed for the customer with where dude was stepping.

[@uik99]

Didnt know KZbin was like google search with fake reviews and fake accounts and fake messages 👎 🤣 GRETA

[@713LiLman]

I am looking for a installer can you please help me I have a 2013 BMW activehybrid 5 series I want to use my factory head unit it plays DVDs and has surround sound processor I have 7.2 channels my subs are under the front seats I have a dedicated center channel it a coaxial 🔊 I want to use a 5 inch coaxial made by focal the DPS I would like to use is the FSP-8 made by focal front doors I would like to have Morel Virtus 502 Virtus Series 5-1/4" component speaker system rear doors Morel Hybrid Integra 52 rear dash I would like to have Morel Virtus 503 - Morel component speaker system subs I would like to use Kicker 46L7T82 L7T Series shallow-mount 8" dual 2-ohm voice coil component subwoofer amps that I would like to have are JL Audio VX1000/5i 5-channel car amplifier with digital signal processing - 75 watts RMS x 4 at 4 ohms + 600 watts RMS x 1 at 2 ohms JL Audio VX400/4i 4-channel car amplifier with digital signal processing - 75 watts RMS x 4 can you please help me thank you Sir

[@jeffgoodrich4577]

Hey dean, awesome build as always. Just a heads up, one of your subscribers who is a constant contributor in the live shows scammed me on some gear. Not your problem of course, just wanted to let you know. She even claimed she texts you directly. Beware

[@Harley-bq2sx]

Call them , Paul will talk to you.

[@jeffgoodrich4577]

@@Harley-bq2sx I don’t want them to waste there time. She’s gone I’m sure. Just didn’t want anyone else getting screwed. She didn’t say she worked for them or anything

[@Harley-bq2sx]

I'm glad u caught on...it getting bad...these scammers are getting worse....

[@SmackedInATL]

Ridiculous install!

[@wayneg296]

👍👍😎✌️🤟

[@mikepetrilli4686]

I had a 2021 GT Premium with a manual MT82 transmission. Complete garbage! I could put up with the cheap plastic interior, engine tick and the glitchy electronics, but the drive train was garbage. Kept the GT for 2 months and unloaded it....was a pile of junk. Bought a real car from another manufacturer with a standard TREMEC couldn't be happier...FU FORD! BTW - if you did buy this POS with a MT82 you can join the class action suit!

[@Bobbrians]

I had a 19gt, the engine ticked bad when cold and the mt82 sounded like an old graintruck transmission, the dual mass flywheel was junk, pedal feel was garbage, would not shift past 7000rpm, spend a few thousand on the trans replacing clutch, flywheel, shifter and trans fluid, shifted great after and pedal felt great but the noises remained finally traded it in for a luxury sedan.

[@morrisdeutsch6175]

A lot of people who don't know how to drive stick had a problem with that transmission. As for the class action lawsuit, if you need $12 that bad, I will give it to you.

[@pheonixfps9248]

How did you wire up the 3 way cross over. I'm running the standard amp, but having trouble wiring up the crossover