Ram Full car stereo 911 install

[@dogsnmotorcycles]

Every time I watch your 911 videos, it re-enforces why trust no one to touch my vehicles.

[@jbmjbm323]

You got that right unless it was these two fella, Dean and Fernando! Plus for my vehicle, I do my own upgrades so if there was a problem, it would be my fault and I can't blame anyone else.

[@courtneythomas3673]

Facts

[@swizlstik]

Being a Ram 1500 owner, I especially like this series.

[@je1279]

You guys are true professionals who take pride in your craft. Such skill and dedication is very rare these days.

[@seangreene4311]

Wish I knew a shop in Southern California that took this much pride in their work. 🙏🔥🔥

[@jbmjbm323]

All these Southern Cali audio shops out there selling good stuff but for install, who knows.

[@paul340mopar]

Man..Things sure have changed since back in the day all we did to upgrade our audio was install a Pioneer Cassette Deck and throw in some Jenson 6x9's in the rear deck and we were Rockin!😎

[@seanhower5130]

This was an amazing install ,quality install you understand and have researched your products and know how to put it all together so that the customer will be extremely happy with the visual aspect and the sound aspect ,in my mind this was a puzzling install ,each vehicle will pick your brain for layout of system yet the end result is just a masterpiece for audiophiles.

[@pastorkurtlin]

I see that red Orion on the wall. I used to run those back in the early 90's. Good ol days

[@theylovedakid3060]

Been goin to dean since 2011..he really is the 🐐

[@speedpros]

Monster job and incredible work to bring the listening experience up to par 👏 . Dude had some good stuff but I tell anybody if it didn't go in right it isn't going to sound great. The first installation was on a decent track but they seem to get lazy, complacent or cheap and just didn't knock it out. Good job guys

[@wisconsinfishingadventures]

That tweeter install was clean! Great job.

[@arnicus208]

One change I would make, because I did on my RAM, is the fuse block position. I initially mounted my down low against the back wall as well. Then discovered how difficult it is to change fuses because of the bottom portion of the seat. I ended up making a platform the attaches to the amp board at the platform’s top edge, and is bolted to the floor with nut-serts at its bottom. The platform itself is on about a 60 degree angle that gives complete access to the fuses and doesn’t interfere with the seat. I used ABS and bent it with heat. Almost like I learned to do that right here!

[@papirivera4747]

You guys do such great work you’re so professional

[@BS-Reviewz]

That tweeter mount for the door was sweet

[@as8907]

it was really satisfying

[@jbmjbm323]

Taping is for protection. I just learned something new. But I use flex sleeve If I want to show off my wire connection that I am using for my sub speaker wire.

[@benbradford8822]

Excellent job!!! Loved watching this. I have a 2020 Ram 2500 and I am getting back into car audio. Very helpful!!!

[@seanbreeden6508]

Very professional install and the workmanship shows. I really enjoy the 911 fix. Shows that other installers need to step up there work when you buy a nice system you expect a great install.

[@danprucnal2410]

Wow. You guys are pros. Quality work guys.

[@johnnyh127]

Very high quality install. Appreciate the time and attention to detail that you guys do.

[@grahamlocke7650]

You guys are totally awesome and know your stuff.Thanks for all the helpful hints and very professional vedeo. Your fabrication work is top notch.thanks for sharing.

[@deone6434]

Was this a re-upload? I feel like I've seen this before. Anyways, can't complain with the awesome job.

[@genericdude6551]

I was getting tired just watching you guys. I hope you're paid well for all that effort.

[@boominS10]

Dm1000 is a 500 watt rms amp that requires an external fuse. DD even says that in the paperwork for all of the DM series amps which are there small amps

[@albono780]

Nice job Guys . Very professional. About how many hours to do a job like this one ?

[@chrisnas1483]

Bravo Dean and Fernando for this 911

[@RandomAudioGuys]

Interesting fact about that DD mat they didnt have on good. If you roll it until the sqaures disapear you would know its put on well, saw that with many DD audio dealers not knowing this.

[@Peedarb]

Literally the only place I would take my car is to five star, if not I'm doing it myself

[@scotto7895]

Always enjoy Ram Videos. I own a 16 Ram with the upgraded Alpine setup. Sure wish you were in the Dallas/Fort Worth area of Texas for my Ram. Any info on trusted Car audio dealers out here you might have experience or knowledge of? Thank you

[@RandomAudioGuys]

Id say this is the difference in the original install costing approx 700.00 Labor and the 5S costing approx 1800.00 Labor. But you can't take away Dean and Fernando's work, it is top notch.

[@jimt5683]

I hope you guy do a daily spl install soon!

[@turbokoni]

Absolute insane! Greetings from Germany!

[@petergraham198]

Great job man

[@TheJeof1000]

Love the series. And I'm planning to upgrade my speakers and add amplifier. But after watching several of your 911 videos I get paranoid...lol...that the shop I will go will cut corners on the install.... How to find a good shop and what questions will I ask to know that the shop is good. Or maybe you can recommend me a shop here in NY. Thanks

[@paul340mopar]

What about the ANC Bypass? Does the Pac Amp Pro do that, I'm about to start my Build and have the Pac AP4-CH41, but I was lead to believe you need a Bypass Harness for the ANC also or you get some sort of Feedback.

[@ghostinthetreeline]

Thank you again for another great video. The 911's are my favorite, and I am addicted to the wiring time-lapse. I'm curious why the customer opted to not use the Sundown sub's and swap to the Rockford Fosgate's. Was it output? Were the Sundown's and the RF's both 10"s? I've heard good things about the Sundown SD v.4 subs and was just curious. I know in some of your 911's, the customer opts to keep/re-use components in another build, but I didn't hear why in this one. Thanks again Dean/Fernando!

[@jerrytipsword3033]

Should of upgraded the subs and kept Sundowns in it. That box looked big enough for SA or U series subs

[@michaelflowers6048]

Very nice install and great work but dang at the room taken up by the equipment. I agree there are a lot more options for smaller equipment that would be more than adequate. One of the biggest problems I see over and over again is people don't research options and plan out their systems before buying equipment. They don't check dimensions of the space in their vehicle versus the dimensions of the equipment and I guess a lot don't know how they just buy equipment

[@DjCBlaq]

Amazing job as always. That amp rack was a piece of art. I do have a question for you. When running multiple amplifiers and a DSP where do you normally do all of the tuning? Because I see that you put the truck back together before you set the DSP, are you making adjustments on the apps themselves or just on the DSP when tuning. Do you just set your default settings on the amps and then do everything else from the DSP?

[@telhack693]

If you had to subtitute the amps, what would you have gone with here?

[@jberry1979]

How long is a vehicle in the shop for an install like this? Is this like a 2-3 day affair, or knock it out all in one? Hard to get a sense of time from the videos.

[@daedae1342]

About 3 to 4 hours of work give or take on what all your doing

[@tirekiller1952]

I would love to have a top notch install in my 2007 Kenworth W900 18 wheeler!! I spend a lot of time on the road and MUSIC IS LIFE! I appreciate many genres, just depends on my mood.

[@lancepfeifer8195]

"Save the tape trees" brilliant idea for another shirt

[@jacksondavid8758]

Why did the owner ditch the sundowns in lieu of the RF subs?

[@evanwhale6127]

How much for a system like this in a mega cab?

[@johnsmith-qz4bv]

great video guys

[@carlosrico7869]

Wish you guys had a shop in the Dallas/Fort-Worth area -- or can you recommend a shop that knowledgeable and takes the same pride in their work as you guys ?

[@thunderdan007]

Was the tweeter in the door custom? Haven’t seen a 3 way system from the factory before.

[@sunsetman9192]

At 14:18 you got me laughing 😂😂😂. I just want to send my truck to you guys.

[@greylonewolf_outdoors]

Hey Dean and fernando, I love your work guys. I have a question for you Dean,? I have a rockford fosgate punch p300 powered sub. I have a problem with the amp staying on. Everything is hooked up properly. I believe it has to do with the inside of the box, question is can that be fixed, how to do it.

[@chrisnas1483]

They didn't know what they were doing.

[@sunsetman9192]

How much you guys charge?

[@mikeangelvaz]

I feel like I learn a lot on what NOT to do with these 911's

[@OG_Fernando]

Never knew about the tape wire...I assumed it was more of a visual to keep the wires looking "stock". #FmL

[@happys104092243]

I'm not a professional audio installer myself. But I would be ripping all that out to. My OCD wouldn't let me leave that in place. I also would run everything clean.

[@stevemassey4871]

Question did y'all run all stock electrical to run in power the amps or did you have to add battery

[@demarcocampbell3057]

I see you're not here in Nashville, do you know any car audio installer here in Nashville that would recommendation?

[@unkowntrooper1657]

What are you using to test the speakers that makes that sound

[@gulenator]

You guys are awesome, always love seeing how you guys solve problems!!

[@JustEnufCustoms]

Super awesome install. 👍✌️

[@06ramsport]

I have a question I have a heigh10 in a 2028 ram and want to know what the most reliable CarPlay wireless adapter is I have kicker all the way around and a single 10 with 400watts for that

[@06ramsport]

2018 is what it was supposed to say

[@paul340mopar]

Okay, For a minute I thought you were from the Future!😃@@06ramsport

[@xvxjimboxvx]

It’s crazy if he went to a shop and paid probably a crazy amount of money and that’s what he got.

[@SenorReflex]

How do you connect the speakers to the amp if you prewired them out if the vehicle

[@shawnkarvonen]

They connected speaker wires by factory amp. They used factory wires I n doors.

[@Thomasr435]

Why would you not try and tune what is in the truck already? Before tearing it all apart... Tune it properly and see if the client is happy, if not then tear out and replace.

[@lenjames]

Goodness...I still listen to AM...I better step up my game

[@derringer9542]

wait wtf..that box is supposed to be down firing????

[@mbr9106]

I Install the Pac Audio for my Ram and I personally don't like the Audio Quality coming out of the Pac Audio. I think my focal speakers sound better with stock radio

[@joelrodriguez7038]

This is the best audio team, brother if you can tell me where is your shop

[@Lazerchicken69]

they are in mid florida I think

[@robertprasse8199]

Clear Water Florida,west coast Tampa bay area

[@Jacob_Callahan]

Do you guys or does anyone that you know of have an advanced audio wiring guide that I can refer to?

[@mikeangelvaz]

What brand of amplifier is that?

[@swizlstik]

DD Audio

[@Jluong538]

Is this a spl or sq build?

[@SenorReflex]

Sq

[@mikeodell5915]

U guys rock

[@01bytor70]

“Save the tape trees!”

[@mildaudiophile3879]

It’s hard to beat the stock harmon kardon and is not a task for the average Joe and a good dsp.I wish they would say who did these install so we could know who to steer away from them

[@zpwslayer9719]

The Sundown's were the better choice over those Rockford P3's.

[@capableman4277]

Ya needed to do a big three upgrade to support that much current draw , and minimize the voltage drop over the factory electrical !

[@phillyracer83]

that install is common here in Philadelphia lol

[@vcjester]

Does nobody bring in a 2500? LOL There are differences..

[@soorajrajankadakkal1509]

👍

[@wayneg296]

👍👍😎✌️🤟. ⭐️⭐️⭐️⭐️⭐️

[@jberry1979]

God, this guy spent a fortune, and got all this great equipment ruined with a bad install and lame box.

[@lilflip1820]

That's a lot of money for poor results. Imagine thinking Audiofrog is the reason for poor sound.

[@cesarc6994]

1

[@diecastdreams4160]

What a mess 😢