this is the older im65 paslode with a nicad battery. exact same setup and repair as the new lithium paslode. #repairs #toolrepair #powertool #tools #carpenter #paslode
Пікірлер: 10
@deanthompson66642 жыл бұрын
Ive just stripped and cleaned wanna these done alot tbh but this one i have atm will fire but odd time leaves pin sticking out say 5mm dont understand did u leave the exhaust reed valve circle mesh on purpose mate as it wasnt installed cheers pal
@deandohertygreaser2 жыл бұрын
it was installed, it was a mistake. had to go back and dismantle the gun again to reinstall it. if the pin is sticking out the problem is the reed strip.
@deanthompson66642 жыл бұрын
@@deandohertygreaser ah asee mate sorry i mean the actual pin nails not the firing pin mate i stripped and cleaned the reed valve area and reed strip and installed correctly
@deandohertygreaser2 жыл бұрын
@@deanthompson6664 make sure your probe depth stop is set right so its driving them as far as possible, also make sure the tip of the firing pin is not snapped of.
@deanthompson66642 жыл бұрын
@@deandohertygreaser think i may have found the problem mate it is firing the pins deep just the odd one sticks outs bit when adjusting the depth wheel seems to do nothing and noticed its not going up or down on the threads maybe the probe threads are buggered so basically wont be attached probe - yoke this probs would be problem u think mate?
@deandohertygreaser2 жыл бұрын
@@deanthompson6664 is it leaving 2 marks when you fire a nail. As in, when it dosent sink the nail, is the a hole beside the nail where the pin hit the wood