G288 Carlton 404 full chisel

[@gunterbecker8528]

Don't give much for u saw,but u running a sharp chain, good to see you have the experience!

[@giuseppelatina2640]

You need that G288 to run that chain and to cut that size wood 🤙

[@SawChainTheories]

@@giuseppelatina2640 The chain is punishing the poor thing. Its factory depth gauge is set at 040 and even after removing a lot of the tooth it is still very low. The saw handled the 36" setup better than this

[@DanRussell-q8s]

Approx. 27 seconds per cut . Chain is cutting great but might I suggest a saw with more power to maximize cutting performance ?

[@SawChainTheories]

@@DanRussell-q8s This chain is definitely suited to a larger saw. The depth gauges come set at .040 (1.2mm) and would be better suited to either a large, low revving saw or the older gear drive saws. I think even the 880 would struggle with this chain but it should come around after another couple of sharpenings. This is the most aggressive factory depth gauge setting I have come across, only their 404 chipper comes close at 037